Kenwood TM-V7E User Manual download pdf (Page 87)

100

REPEATER FUNCTION (U.S.A./ CANADA ONLY)

This transceiver is capable of repeating signals originating

from either the VHF or UHF band. For example, a signal

received on the VHF band is retransmitted on the UHF

band. Similarly, a signal received on the UHF band is

retransmitted on the VHF band. You can choose Locked-

band Repeater mode or Cross-band Repeater mode.

Note:

◆

You cannot activate the Repeater function after switching ON the

DTSS or Page, after selecting VHF/VHF or UHF/UHF mode, or while

blanking a band display.

◆

Activating the Repeater function switches OFF Automatic Band

Change (A.B.C.) or Automatic Simplex Checker (ASC).

◆

The Time-Out Timer is locked at 3 minutes.

LOCKED-BAND REPEATER

The transceiver always uses the same band to receive or

transmit a signal as a repeater.

1 Press the right or left [BAND SEL] depending on which

band will be used for transmitting.

2 Press the left [BAND SEL]+[ ] to enter Locked-band

Repeater mode.

• “PTT” blinks.

•To exit this mode, repeat the same key operation.

CROSS-BAND REPEATER

Unlike Locked-band Repeater mode, the transceiver can

also switch the current RX only band to the TX band when

receiving a signal on the TX band.

1 Press the right or left [BAND SEL].

2 Press [CONT SEL].

3 Press the left [BAND SEL]+[ ] to enter Cross-band

Repeater mode.

• “PTT” blinks.

•To exit this mode, repeat the same key operation.

TX HOLD

This function keeps the transceiver in transmit mode for

approximately 500 ms after signals drop.

1 Press [MNU] to enter Menu mode.

2 Select Menu No. 17 (Repeater).

3 Press

[SET]

to toggle the function ON (default) or OFF.

4 Press [MNU] again to exit Menu mode.

VOL SQL

CALL

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 99 100

Comments to this Manuals

No comments

Kenwood TM-V7E User Manual Page 87

Comments to this Manuals

Related products and manuals for Acoustics Kenwood TM-V7E