Kenwood TM-V7E User Manual download pdf (Page 75)

100

POWER-ON MESSAGE

Each time you switch the transceiver ON, the factory-default

message appears and stays for approximately 2 seconds.

You can program your favorite message in place of

“KENWOOD”.

1 Press [MNU] to enter Menu mode.

2 Select Menu No. 2 (Front Panel).

3 Press

[

]

, then select Item No. 2 (Power On Msg).

4 Press

[SET]

• The last digit blinks.

5 Press [VFO].

• The cursor moves to the first digit.

6 Turn the Tuning control, or press Mic [UP]/[DWN], to

select the first digit.

•To skip by four characters when operating the above

control or keys, press [MHz]. Press [MHz] again to quit

this jump function.

7 Press

[

]

• The second digit blinks.

8 Repeat steps 6 and 7 to enter up to 7 digits.

• After entering the 7th digit, pressing

[

]

causes an error

beep to sound.

•To re-enter the preceding digit, press

[

]

•To clear all digits and move back to the first digit, press

[VFO].

9 Press

[SET]

again to complete the setting.

10 Press [MNU] to exit Menu mode.

DISPLAY DEMONSTRATION MODE

By initiating this mode, various pre-programmed displays

appear. You still can normally use the transceiver in this

mode. Pressing buttons or microphone keys, or turning the

Tuning control restores the operating display immediately.

If there is no button/key entry or Tuning control adjustment

for approximately 12 seconds, the transceiver reverts back

to Demonstration mode.

Press

[F]

+[ ] to toggle the mode ON or OFF.

VOL SQL

CALL

VOL SQL

CALL

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 99 100

Comments to this Manuals

No comments

Kenwood TM-V7E User Manual Page 75

Comments to this Manuals

Related products and manuals for Acoustics Kenwood TM-V7E