Kenwood TM-V7E User Manual download pdf (Page 8)

MOBILE INSTALLATION

Install the transceiver in a safe, convenient position inside

your vehicle that minimizes danger to your passengers and

yourself while the vehicle is in motion. For example,

consider installing the transceiver under the dash in front of

the passenger seat so that knees or legs will not strike the

radio during sudden braking of your vehicle. Try to pick a

well-ventilated location that is shielded from direct sunlight.

■ Installation Example

Use the supplied mounting bracket to install the

transceiver inside your vehicle. To enjoy the best

viewing angle, you can position the transceiver in the

bracket in a number of ways as shown below.

■ Installation Steps

1 Install the mounting bracket in the vehicle using the

supplied flat washers and self-tapping screws.

There are 4 washers and 4 screws supplied.

• The bracket can be mounted with the bracket opening

for the transceiver facing down for underdash

mounting, or with the opening facing up.

• The bracket must be installed so that the 4 screw

holes on the edge of each bracket side are facing

forward.

2 Position the transceiver, then insert and tighten the

supplied hexagon SEMS screws and washers.

There are 2 screws and 2 washers supplied for each

side of the bracket.

• Double check that all hardware is tightened to prevent

vehicle vibration from loosening the bracket or

transceiver.

PREPARATION FOR MOBILE AND FIXED STATION OPERATION

8MAX

Flat washer

Self-tapping

screw

KENWOOD

FM DUAL BANDER TM-V7

SEMS screw

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 99 100

No comments

Kenwood TM-V7E User Manual Page 8