Kenwood TM-V7E User Manual Page 62

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 61
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
56
Note:
If, after Page has opened the squelch, no signal is received for more
than 2 seconds, the squelch will close.
"Err" appears on the display if your transceiver fails to receive the
Page code correctly.
Page may not function in the following situations:
The other station is using a battery saver function.
A repeater ID and the Page code are received simultaneously.
If difficulty is experienced in these cases, press
[MR]
while in the
transmit mode. The Page code is re-transmitted.
Page cannot be used with some repeaters.
Page also may not function if buttons are pressed or the
VOL
control
is turned while a valid Page code is received.
When Page is ON, scan cannot be used.
Page and Repeaters
Pressing Mic [PTT] transmits the Page codes after a
short delay. When using repeaters with long response
times, this delay helps the repeater avoid losing a
portion of the Page codes. The delay time is 350 ms
during simplex operation.
When using a transmit offset or a split frequency, you
can select either 350 ms (default) or 550 ms.
To select the delay time, use the procedures described
in "DTSS and Repeaters" {page 52}. This setting is
shared with DTSS.
LOCKING OUT PAGE CODES
This function is useful if you wish to inhibit the transceiver
from receiving specific Group codes. When called with
your Station code, Page Lockout does not inhibit the
transceiver from receiving. After locking out the desired
Group codes, you can still use those codes to transmit.
1 Select the desired band.
2 Switch Page ON.
3 Press
[F] (1 s), [C.SEL]
.
4 Turn the Tuning control, or press Mic [UP]/[DWN], to
select the desired channel.
5 Press
[L.OUT]
to toggle Lockout ON or OFF.
"L" appears beside the Page code to indicate that the
Page code has been locked out.
6 Press
[OFF]
or Mic [PTT] to restore the frequency
display.
Repeat the above procedures to unlock the channels.
Note:
You cannot lock out memory channel 0.
Page view 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 99 100

Comments to this Manuals

No comments