Kenwood TM-V7E User Manual download pdf (Page 68)

AUTOMATIC BAND CHANGE (A.B.C.)

A.B.C. will temporarily switch the RX only band to the TX

band immediately after a signal is received on the RX only

band. This function allows you to reply to a caller without

manually selecting the correct band.

Press

[F]

, [MNU] to toggle the function ON or OFF.

• "A.B.C." appears when the function is ON.

• Pressing [BAND SEL] or Mic [PTT] also cancels A.B.C.

• The original TX band is restored 2 seconds after the signal

drops out.

Note:

◆

You cannot use A.B.C. when in Single-band mode. After activating

A.B.C., changing from Dual-band mode to Single-band mode

deactivates A.B.C. Switching back to Dual-band mode re-activates

A.B.C.

◆

After activating A.B.C., starting Visual Scan deactivates A.B.C.

Canceling Visual Scan re-activates A.B.C.

ADVANCED INTERCEPT POINT (AIP)

AIP helps eliminate interference and reduce audio

distortion caused by intermodulation. This problem is often

apparent in urban areas when the RX band is extremely

crowded.

1 Select the desired band.

2 Press [MNU] to enter Menu mode.

3 Select Menu No. 9 (AIP).

• "VHF AIP" or "UHF AIP" appears depending on which

band you selected.

4 Press

[SET]

to toggle the function ON or OFF (default).

5 Press [MNU] again to exit Menu mode.

Note:

While using VHF/VHF RX or UHF/UHF RX, switching the AIP

function ON or OFF on the main band also activates or deactivates AIP

on the sub band.

VOL SQL

CALL

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 99 100

No comments

Kenwood TM-V7E User Manual Page 68