Kenwood TM-V7E User Manual download pdf (Page 91)

100

3 Connect the other end of the connectorized front panel

cable to the One Touch panel.

• The cut-away corners of the connector should be inserted

first into the space such that the corners mate with the

positioning tab.

4 Install the front panel onto the One Touch panel by first

positioning the left rear edge of the front panel, then

pressing the right side of the front panel firmly against

the One Touch panel.

• When the release switch clicks, the front panel is secured.

5 Assemble the mounting brackets, and install the front

panel on the appropriate place in the vehicle.

• When installing the front panel in the vehicle, use a

cushion under the bracket to protect the vehicle.

• Adjust the angle of the front panel before firmly tightening

the two Allen screws.

• Route the cable so neither the connections nor the cable

are under stress.

Note:

Consider the safety of driver and passengers when deciding

where to install the front panel. Tighten all screws firmly.

Cut-away corner

Screw

Bracket

Positioning tab

Allen screw

Cushion

Flat washer

Self-tapping screw

(3 mm x 14 mm)

Flat washer

Self-tapping screw

(3 mm x 6 mm)

Allen

wrench

Allen screw

Cushion

One Touch panel

6 mm

14 mm

Onto the

appropriate place

in the vehicle

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 99 100

Comments to this Manuals

No comments

Kenwood TM-V7E User Manual Page 91

Comments to this Manuals

Related products and manuals for Acoustics Kenwood TM-V7E