Kenwood TM-V7E User Manual download pdf (Page 83)

100

MICROPHONE CONTROL

You can also make the following settings by pressing

[F]

first (ex.

[F]

, Mic [2]).

After activating the Tone function, press

[F]

, Mic [2], then

press [ ] or [#] to change the tone frequency.

U.S.A./ Canada only

Note:

◆

U.S.A. only:

It is illegal to transmit control codes on the VHF band.

Transmit control codes only on the UHF band.

◆

You cannot activate both Volume Change and Squelch Adjustment at

the same time.

◆

When you recall a memory channel containing DTSS or Page ON

status after activating Microphone Control, DTSS or Page will not

function.

Key

FunctionKey

Tone Select

Offset Direction Select

DTMF Keypad Lock

DTMF Keypad Unlock

Repeater Function

Function

You can change numerous transceiver settings with the

MC-53DM or MC-45DM microphone without using the

transceiver buttons or controls. DTMF tones are used for

this remote control operation. First switch Microphone

Control ON using Menu Set-up {page 78}.

Note:

Audible DTMF tones from other transceivers near you may be

picked up by your MC-53DM or MC-45DM microphone. If so, this could

prevent the functions from working correctly.

The following table shows what function is switched ON

and OFF or which setting is changed by pressing the

DTMF keys.

Transceivers equipped with the optional VS-3 unit

announce the displayed information {page 82}.

After pressing this key, press [ ] to lower or [#] to raise

the level.

Key

FunctionKey

Visual Scan

Tone/ CTCSS

Reverse

1 MHz Step Change

Monitor

Frequency Readout

by Beeps

Volume Change

Dual Band RX

Squelch Adjustment

TX Power Change

Enter

Control Band Select

—

[F]

key

Frequency Down

Frequency Up

Function

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 99 100

Comments to this Manuals

No comments

Kenwood TM-V7E User Manual Page 83

Comments to this Manuals

Related products and manuals for Acoustics Kenwood TM-V7E