Kenwood TM-V7E User Manual download pdf (Page 53)

100

■ Using Program Scan

1 Select a frequency equal to or between the

programmed scan limits.

2 Press [VFO] (1 s).

• The 1 MHz decimal blinks while scanning is in

progress.

• Scan starts at the frequency currently displayed.

3 To reverse the scan direction, turn the Tuning

control or press Mic [UP]/[DWN].

• Upward scan:

Turn the Tuning control clockwise or press Mic [UP].

• Downward scan:

Turn the Tuning control counterclockwise or press Mic

[DWN].

4 To quit Program Scan, press [BAND SEL] for the

band being scanned or [VFO].

• When scanning the TX band, you can also press Mic

[PTT] to quit Scan.

Note:

◆

The squelch must be closed for Scan to function.

◆

If the frequency step of the current VFO frequency differs from

the frequency step of the programmed frequencies, you cannot

use Program Scan.

◆

If the frequency step of the lower limit and upper limit differ, you

cannot use Program Scan.

◆

If the current VFO frequency is within more than one scan range,

Scan starts with the range stored in smaller channel numbers.

MHz SCAN

MHz Scan allows you to scan a 1 MHz segment of the

band. The current 1 MHz digit determines the limits of the

scan. For example, if the current frequency is 438.400

MHz, then MHz Scan would scan from 438.000 MHz to

438.975 MHz. The exact upper limit depends on the step

size selected.

1 Select the desired band.

2 Start VFO Scan or Program Scan first.

3 Press [MHz] to start MHz Scan.

4 To quit MHz Scan, press [MHz] again.

• If the current frequency is within the program scan range

when stopping MHz Scan, Program Scan resumes.

Otherwise, VFO Scan resumes.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 99 100

Comments to this Manuals

No comments

Kenwood TM-V7E User Manual Page 53

Comments to this Manuals

Related products and manuals for Acoustics Kenwood TM-V7E