Kenwood TM-V7E User Manual download pdf (Page 10)

2 Connect the transceiver’s DC power connector to

the connector on the DC power cable.

• Press the connectors firmly together until the locking

tab clicks.

Note:

◆

For your transceiver to fully exhibit its performance capabilities,

the following optional power supply is recommended:

PS-33 (20.5 A, 25% duty cycle).

◆

Before connecting the DC power supply to the transceiver, be

sure to switch the transceiver and the DC power supply OFF.

◆

Do not plug the DC power supply into an AC outlet until you

make all connections.

Press

firmly.

Fuse holder

■ Fixed Station Operation

In order to use this transceiver for fixed station

operation, you will need a separate 13.8 V DC power

supply that must be purchased separately. The

recommended current capacity of your power supply is

12 A.

1 Connect the DC power cable to the regulated DC

power supply and check that polarities are correct

(Red: positive, Black: negative).

• DO NOT directly connect the transceiver to an

AC outlet!

• Use the supplied DC power cable to connect the

transceiver to a regulated power supply.

• Do not substitute a cable with smaller gauge

wires.

Regulated DC power

supply

Fuse holder

Black (–)

Red (+)

To AC outlet

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 99 100

No comments

Kenwood TM-V7E User Manual Page 10