Kenwood TM-V7E User Manual download pdf (Page 49)

100

■ Selecting Scan Resume Method

1 Select the desired band.

2 Press [MNU] to enter Menu mode.

3 Select Menu No. 8 (Scan Resume).

4 Press

[SET]

to toggle Time-Operated or

Carrier-Operated.

5 Press [MNU] again to exit Menu mode.

SCAN RESUME METHODS

Before using Scans other than Visual Scan, it’s necessary

to decide under what condition you want your transceiver to

continue scanning after detecting and stopping for a signal.

You can choose Time-Operated mode or Carrier-Operated

mode. The default is Time-Operated mode.

• Time-Operated mode

Your transceiver stops scanning after detecting a signal,

remains there for approximately 5 seconds, and then

continues to scan even if the signal is still present.

• Carrier-Operated mode

Your transceiver stops scanning after detecting a signal and

remains on the same frequency until the signal drops out.

There is a 2 second delay between signal drop-out and scan

resumption to allow time for any responding stations to begin

transmitting.

Note:

◆

Turning the

Tuning

control clockwise, or pressing Mic

[UP]

after a

signal that has stopped Scan drops out, causes scanning to resume

immediately upward.

◆

Turning the

Tuning

control counterclockwise, or pressing Mic

[DWN]

after a signal that has stopped Scan drops out, causes scanning to

resume immediately downward.

VOL SQL

CALL

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 99 100

Comments to this Manuals

No comments

Kenwood TM-V7E User Manual Page 49

Comments to this Manuals

Related products and manuals for Acoustics Kenwood TM-V7E