Kenwood NX-800E User Manual download pdf (Page 29)

VGS-1 OPTIONAL VOICE GUIDE & STORAGE UNIT

voice recorder

The voice recorder allows you to record conversations and create voice memos.

■ Auto Recording

If activated, the auto recorder will continuously record all transmitted and

received signals. The recording storage area retains only the last 30 seconds

of recording.

■ Voice Memos

To record a voice memo for later playback:

1 Press the key programmed as Voice Memo, press and hold the key

programmed as Playback, or access the Menu {page 9}.

• The duration of recording memory will appear on the display and begin counting

down.

2 Speak into the microphone to record your memo.

3 Press to end the recording and store it in memory.

• If the memory becomes full, recording will stop and the voice memo will be

stored in memory.

■ Auto Reply Message

You can set the transceiver to automatically respond to Individual Calls while

using FleetSync/NXDN.

1 Press the key programmed as Auto Reply Message to enter Auto Reply

Message mode.

2 When you receive an Individual Call, the transceiver will send an automatic

response to the caller after 3 seconds, and “GREETING” appears on the

display.

• If you are available to receive the call, press any key to cancel the auto

response.

• If there is memory available on your transceiver for recording, “I am not available.

Leave your Message.” will be sent to the caller and they can leave a recorded

message. When a message is stored on your transceiver, “Msg Rcvd” appears

on the display.

• If no memory is available on your transceiver, “I am not available” will be sent to

the caller and “ MEMORY FULL” appears on the display.

1 2 ... 24 25 26 27 28 29 30 31

No comments

Kenwood NX-800E User Manual Page 29