Kenwood NX-800E User Manual download pdf (Page 15)

BASIC OPERATIONS

SwiTching power on/oFF

Press and hold the switch for approximately 1 second to turn the transceiver

power ON. Press and hold the switch again to turn the transceiver OFF.

■ Transceiver Password

If the transceiver is password protected, “PASSWORD” will appear on the

display when the power is turned ON. To unlock the transceiver, enter the

password:

1 Select a character using / .

• If you are using a microphone keypad, you can enter the password direclty.

2 Press to enter the selected character.

• This step is unnecessary when using the keypad.

3 Repeat steps 1 and 2 to enter the entire password.

• Press or # to delete a character. Press and hold or # to delete all

characters.

4 Press or to conrm the entry.

• If you enter an incorrect password, an error tone sounds and the transceiver

remains locked.

• The password can contain a maximum of 6 digits.

AdjuSTing The volume

Press the keys programmed as Volume Up/ Volume Down to adjust the volume.

SelecTing A Zone And chAnnel/group id

Select the desired zone using / (default). Each zone contains a group of

channels.

Select the desired channel/group ID using / (default). Each channel/group ID

is programmed with settings for transmitting and receiving.

• You can toggle the display between the zone and channel/group ID names and number

by pressing the key programmed as Display Format, or by accessing the Menu {page 9}.

Note: If the default settings for / and / have been changed, use the appropriate keys to

select the zone and channel/group ID.

TrAnSmiTTing

1 Select the desired zone and channel/group ID.

2 Press the key programmed as Monitor or Squelch Off to check whether or

not the channel is free.

• If the channel is busy, wait until it becomes free.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 30 31

No comments

Kenwood NX-800E User Manual Page 15