Kenwood NX-800E User Manual download pdf (Page 11)

inSTAlling The TrAnSceiver

For passenger safety, install the transceiver securely using an optional mounting bracket and screw

set so the transceiver will not break loose in the event of a collision.

1 Mark the position of the holes in the dash by using the mounting bracket as a

template. Drill the holes, then attach the mounting bracket using self-tapping

screws.

• Be sure to mount the transceiver in a location where the controls are within easy

reach of the user and where there is sufcient space at the rear of the transceiver for

cable connections.

2 Connect the antenna and power cable to the transceiver.

3 Slide the transceiver into the mounting bracket and secure it using

hex-headed screws.

4 Mount an optional microphone hanger in a location where it will be within easy

reach of the user.

• The optional microphone and microphone cable should be mounted in a location

where it will not interfere with the safe operation of the vehicle.

When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same value.

Never replace a fuse with a fuse that has a higher value.

Hex-headed

screws

DC power

cable

Mounting

bracket

Antenna

connector

Power input

connector

Fuse

Black (–) cable

Red (+) cable

12 V vehicle

battery

Optioinal

microphone

Ignition

sense cable

Flat washer

Spring washer

Self-tapping screw

External

speaker jack

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

No comments

Kenwood NX-800E User Manual Page 11