Kenwood NX-800E User Manual download pdf (Page 25)

Selecting a Number from the List

1 Select your desired zone and telephone group ID.

2 Press the key programmed as Autodial.

• The last called unit appears on the display.

3 Press / to select your desired list number.

4 Press the PTT switch to start the call.

■ Receiving a Telephone Call

When a call is received, press and hold the PTT switch to speak, and release

it to receive.

• Only one person can speak at a time.

emergency cAllS

If your transceiver has been programmed with the Emergency function, you can

make emergency calls.

1 Press and hold the key programmed as Emergency.

• Ask your dealer for the length of time necessary to hold this key before the

transceiver enters Emergency mode.

• When the transceiver enters Emergency mode, it will change to the Emergency

channel and begin transmitting based on how it is set up by your dealer.

2 To exit Emergency mode, press and hold the Emergency key again.

• If the Emergency mode completes a preset number of cycles, Emergency mode will

automatically end and the transceiver will return to the zone and channel that was in

use before Emergency mode was entered.

Note:

◆ Your dealer can set the transceiver to emit a tone when transmitting in Emergency mode.

◆ Your dealer can set the transceiver to emit tones and received signals as normal, or mute the

speaker during Emergency operation.

ScrAmbler

Press the key programmed as Scrambler/ Encryption, or access the Menu

{page 9}, to switch the transceiver to secure (encrypted) transmission.

• Pressing the microphone PTT switch after the Scrambler function has been turned ON

encrypts the transmitted signal.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31

No comments

Kenwood NX-800E User Manual Page 25