Kenwood NX-800E User Manual download pdf (Page 22)

FleetSync is an Alphanumeric 2-way Paging Function, and is a protocol owned by

Kenwood Corporation.

Note: This function is available only in analog operation.

SelcAll (SelecTive cAlling)

A Selcall is a voice call to a station or group of stations.

■ Transmitting

1 Select your desired zone and channel.

2 Press the key programmed as Selcall or Selcall + Status to enter Selcall

mode.

3 Press / to select the station you want to call.

• If you are using a microphone keypad and Manual Dialing is enabled, you can

directly enter the station ID.

4 Press the PTT switch and begin your conversation.

■ Receiving

An alert tone will sound and the transceiver will enter Selcall Mode. The

calling station’s ID will appear when a Selcall is received. You can respond to

the call by pressing the PTT switch and speaking into the microphone.

■ Identification Codes

An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.

Each transceiver has its own ID.

• Enter a Fleet number (100 ~ 349) to make a group call.

• Enter an ID number (1000 ~ 4999) to make an individual call in your eet.

• Enter a Fleet number to make a call to all units in the selected eet (Fleet call).

• Enter an ID number to make a call to the selected ID in all eets (Supervisor call).

• Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).

STATuS meSSAge

You can send and receive 2-digit Status messages which may be decided in your

talk group. Messages can contain up to 16 alphanumeric characters. Status

messages range from 10 to 99 (80 ~ 99 are reserved for special messages).

A maximum of 15 received messages (combined status messages and short

messages) can be stored in the stack memory of your transceiver.

■ Transmitting

1 Select your desired zone and channel.

2 Press the key programmed as Status to enter Status mode (proceed to

step 5) or Selcall + Status to enter Selcall mode (proceed to step 3).

FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 30 31

No comments

Kenwood NX-800E User Manual Page 22