Kenwood TM-441A User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 59
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
® ★ ¿/¿/ Indicates the active memory channel
number. ★ indicates that the chan
nel is locked out.
C is displayed during call channel.
Either PO, PI, P2, P3, or PA is dis-
played during paging.
® F I On whenever the F key has been de
pressed. Also shows the last memory
channel number that had been se
lected.
On when the Tone Alert function is
active. The indicator flashes when
signal has been received.
On when the Tone Decode and En
code function has been activated.
On when the Tone Encode function
has been activated.
On when the Priority Alert function
has been activated.
On when the Reverse function has
been activated.
@ — + Display the selected transmitter off
set direction.
Both — and + light at the same
time during split channel operation.
@ :388.888s Displays the operating frequency to
the nearest kHz digit; or the tone
frequency etc.
— The indicator flashes when scan
ning.
5-1-3 Rear Panel
@ CTCSS
I
____
AL
REV
©ANTENNA connector
Attach an antenna with a low SWR and an
impedance of 50 ohms.
© 13.8 VDC power input connector
Connect the supplied DC power cable to this
connector.
Pay close attention to the polarity. Red is positive and
black is negative.
d)Fuse holder
Contains a requaired fuse.
TM-241A: 15A, TM-441A: lOA, TM-541A: 8A
Do not use a larger fuse as damage might result to
the transceiver.
0 External speaker jack
This jack is used to connect an external speaker. The
speaker should have an impedance of 8 ohms.
14
Page view 13
1 ... 13 14 15 ... 59

Comments to this Manuals

No comments