Kenwood TM-441A User Manual download pdf (Page 12)

Press this key to activate the call channel function.

Press the F key momentarily and then press the

CALL key to store the currently displayed data into

the CALL channel. The radio will allow you up to 10

seconds to press the CALL key after pressing the F

key.

Pressing the F key for longer than 1 second and then

pressing the CALL key will store the currently

displayed data as the lower limit for the

programmable VFO tuning limit function.

To operate the transceiver with the RC-10 press and

hold the CALL key on the transceiver and then turn

on the POWER switch.

(DSHIFT/AL key

SHIFT function

Pressing this key alone to select the desired

transmitter offset direction. Pressing the key will

cause the radio to shift from one offset direction to

the next, i.e. “+” to " to simplex where no

indicator shows, (“—’’to“— —’’ for European

versions)

AL function

Pressing the F key momentarily and then pressing

the SHIFT/AL key will cause the radio to activate the

Priority Alert function. When this function is active

the radio will scan memory channel 1 at approxi

mately a 5 second interval. If there is activity on the

frequency a beep will sound from the speaker.

Pressing the same key sequence again will cancel

the function.

Pressing the F key for longer than 1 second and then

pressing the SHIFT/AL key will store the currently

displayed data as the upper limit for the program

mable VFO tuning limit function.

(DTONE/T.ALT key

TONE function

Pressing this key by itself causes the radio to select

the desired tone signaling mode. When the “T’’

indicator is illuminated in the display the transceiver

will transmit the selected subaudible tone. When

the “CTCSS’’ indicator is illuminated the transceiver

will both transmit the subaudible tone and will also

remain squelched until the proper subaudible tone

is received.

TONE frequency selection

Pressing the F key for longer than 1 second and then

pressing the TONE/T.ALT key will allow you to select

the desired tone frequency. To change to a

different tone frequency rotate the tuning control

or press the UP/DWN switches on the microphone

until the desired tone frequency appears in the

display. To return to the normal frequency display

you can press any front panel key except the power

switch.

TONE ALERT function

If you press the F key momentarily and then press

the TONE / T.ALT key, T.ALT function will be

activated. This function will cause the radio to emit

a series of beeps when an incoming signal is

received. (See page 47)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 58 59

Comments to this Manuals

No comments

Kenwood TM-441A User Manual Page 12

Comments to this Manuals

Related products and manuals for Boating Accessories Kenwood TM-441A