Kenwood TS-850S User Manual download pdf (Page 32)

MODE key

Press the CW / FSK key to

alternate between CW and

FSK.

RIT/XIT switch/control

NOTCH switch/control

NB switch/control

NB1 : For pulse type noise,

such as generated by

automotive ignition

systems.

NB2 : Noise blanker 2 is

used for long duration

pulse noise, like the

“woodpecker”.

RF gain control

This control should be all the

way to the right.

TONE control

Turn the control to increase

or decrease the tone.

SLOPE TUNE control

ency

jning

I Hz

M.CH/VFO CH control

This control is used to

change the frequency in 10

kHz steps during VFO

operations.

This control is also used to

select the desired memory

channel during Memory

Channel Operation.

RTTY terminal

For connection to an RTTY inter

face unit. A shorting pin is insert

ed into the RTTY terminal at the

factory. With the shorting pin in

serted, the mark signal with the

display frequency is transmitted.

If the shorting pin is removed,

the space signal is transmitted.

'®o o o

RTTY DSP 1 OSP 2

ACC2 connector

Connect to the FSK terminal.

S © © © M ®

ANTI GAIN 0£LAY key

------

VOX

-------

(TRANSMISSION)

D Connect the RTTY keyboard to the RTTY terminal on the rear panel.

B Turn on the DC power supply and then turn the transceiver’s power

switch ON.

B A frequency is shown in the display.

D Select FSK with the MODE key.

B Enter the desired frequency.

Before transmitting check the frequency for activity so that you do

not interrupt another QSO.

B Press the METER key until the ALC meter lights.

B Set the REC/SEND switch to SEND. Or key the transceiver from the

FSK terminal.

B Adjust the CAR control so that the meter deflection is within the ALC

zone.

s —I—I—1

-------

1—1

---------

1---------------1---------------r

OOOaaQOQODODQOQOOODDOOOQDDQQQD

SVR ooooooooocaaoaaaoooaooooooooooa

I^ALC zone-^

B Operate the RTTY keyboard.

B the REC/SEND switch to REC or unkey the transceiver from the

FSK terminal to return to the receive mode.

ACC 2 connections.

The FSK shift width is set to 170 Hz. It can

be changed to 200,425 or 850 Hz. (Please

refer to Section 4-10-15.)

The FSK receive tone is set to 2125 Hz

(high). It can be changed to 1275 Hz (low).

(Please refer to Section 4-10-15.)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 84 85

Comments to this Manuals

No comments

Kenwood TS-850S User Manual Page 32

Comments to this Manuals