Kenwood TM-D700A User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 99
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
3
1
Front Panel Installation
1 Assemble the mounting brackets using the
supplied 2 hexagon SEMS screws and 2 flat
washers.
Do not completely tighten the screws in this step.
2 Peel off the paper backing from the rear of the
bracket.
3 Position the bracket in the vehicle, then install it
securely using the supplied 3 self-tapping screws
and 3 flat washers.
4 Position the grooves on the front panel over the
bracket tabs.
5 Slide the front panel down until its locking tab
clicks.
The tab on the front panel must be completely locked
by the bracket; otherwise vehicle vibration may
cause the front panel to drop off the bracket.
6 Determine the angle of the front panel, then
completely tighten the 2 SEMS screws on the
bracket.
SEMS screw
Self-tapping screw
(4 mm x 14 mm)
Flat washer
Bracket tab
Locking tab
SEMS screw
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 98 99

Comments to this Manuals

No comments