Kenwood TS-480SAT User Manual Page 9
- Page / 104
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
1
INSTALLATION
MOBILE INSTALLATION
When you use this transceiver for mobile operation, do not attempt to perform any kind of configuration or menu
setup configuration while driving your car; it is simply too dangeous. Stop the car and then perform transceiver
configuration. In addition, do not wear headphones while driving.
You should install the transceiver in a safe and convenient position inside your vehicle so as not to subject
yourself to danger while driving. For example, install the transceiver under the dash in front of the passenger seat
so that knees or legs will not strike the transceiver if you brake suddenly. Additionally, do not install the
transceiver and its accessories on to the air bag lids. We recommend you consult your car dealer for the
transceiver installation to ensure safety.
INSTALLATION EXAMPLE
1 Attach the 2 L-brackets using the 6 supplied SEMS screws (M4 x 10 mm) as shown below.
2 Position the transceiver in the mounting bracket and tighten the 4 supplied tapping screws (5 mm x 16 mm) to
fix the transceiver in place.
Do not install the TX/ RX unit in non-ventilated areas. Air must flow through the TX/ RX unit to keep the unit cooled.
REMOTE CONTROL PANEL INSTALLATION
1 Peel off the adhesive tape cover from the bottom of the fan-shaped base.
2 Afix the holder to the vehicle with 4 tapping screws.
3 Attach the Remote Control panel holder to the base with 2 supplied SEMS screws.
PADDLE
KEY
EXT.SP DATA REMOTE
COM
MIC
PANEL
SEMS screw
(M4 x 10 mm)
Tapping screw
(5 mm x 16 mm)
Flat washer
(5 mm)
L-bracket
Remote Control
panel holder
SEMS screws
(M4 x 10 mm)
Adhesive tape cover
Flat washer (4 mm)
Tapping screw
4 mm x 12 mm
- TS-480HX 1
- TS-480SAT 1
- FCC WARNING 2
- BY THE FCC 2
- THANK YOU 3
- PRECAUTIONS 5
- CONTENTS 6
- INSTALLATION 9
- 1 INSTALLATION 10
- ANTENNA CONNECTION 10
- GROUND CONNECTION 10
- IGNITION NOISE 10
- DC POWER CABLE CONNECTION 10
- )renutannetnalanretxenaroF( 13
- TX/ RX UNIT 15
- REMOTE CONTROL PANEL 15
- YOUR FIRST QSO 16
- 2 YOUR FIRST QSO 17
- TRANSMISSION 17
- GETTING ACQUAINTED 18
- 3 GETTING ACQUAINTED 19
- LCD DISPLAY 21
- REMOTE CONTROL PANEL (REAR) 25
- MICROPHONE 25
- OPERATING BASICS 26
- 4 OPERATING BASICS 27
- SELECTING A BAND 27
- SELECTING A MODE 27
- ADJUSTING SQUELCH 27
- SELECTING A FREQUENCY 27
- SELECTING TRANSMISSION POWER 28
- MICROPHONE GAIN 29
- MENU SETUP 30
- 5 MENU SETUP 31
- MENU CONFIGURATION 31
- )1ECIOV( 33
- )INOMXR( 33
- ALPHABETICAL FUNCTION LIST 34
- BASIC COMMUNICATIONS 35
- 6 BASIC COMMUNICATIONS 36
- AUTO ZERO-BEAT 37
- ENHANCED COMMUNICATIONS 38
- 7 ENHANCED COMMUNICATIONS 39
- TRANSMITTING A TONE 40
- TONE FREQ. ID SCAN 40
- CTCSS FREQ. ID SCAN 41
- COMMUNICATING AIDS 42
- 8 COMMUNICATING AIDS 43
- AGC (AUTOMATIC GAIN CONTROL) 43
- VOX (VOICE-OPERATED TRANSMIT) 44
- SPEECH PROCESSOR 45
- TX Filter Bandwidth (SSB/ AM) 46
- TX Equalizer (SSB/ FM/ AM) 46
- Frequency Response Curves 46
- CHANGING KEYING SPEED 47
- AUTO WEIGHTING 47
- BUG KEY FUNCTION 48
- CW MESSAGE MEMORY 48
- FREQUENCY CORRECTION FOR CW 49
- AUTO CW TX IN SSB MODE 49
- MIC UP/ DWN KEY PADDLE MODE 49
- SPECIALIZED COMMUNICATIONS 50
- 9 SPECIALIZED COMMUNICATIONS 51
- SLOW SCAN TV/ FACSIMILE 52
- REJECTING INTERFERENCE 53
- 10 REJECTING INTERFERENCE 54
- BEAT CANCEL (SSB/ FM/ AM) 55
- NOISE REDUCTION (ALL MODES) 55
- PRE-AMPLIFIER 57
- ATTENUATOR 57
- CW REVERSE (RECEPTION) 57
- MEMORY FEATURES 58
- 11 MEMORY FEATURES 59
- MEMORY RECALL AND SCROLL 59
- MEMORY TRANSFER 60
- STORING FREQUENCY RANGES 61
- MEMORY CHANNEL LOCKOUT 62
- ERASING MEMORY CHANNELS 62
- MEMORY CHANNEL NAME 62
- STORING INTO QUICK MEMORY 63
- TEMPORARY FREQUENCY CHANGES 63
- QUICK MEMORY ➡ VFO TRANSFER 63
- VFO SCAN 64
- PROGRAM SCAN 64
- 12 SCAN 65
- PROGRAM SCAN PARTIALLY SLOWED 65
- SCAN HOLD 65
- SCAN RESUME METHOD 66
- ALL-CHANNEL SCAN 66
- GROUP SCAN 67
- OPERATOR CONVENIENCES 68
- 13 OPERATOR CONVENIENCES 69
- BEEP FUNCTION 70
- BRIGHTNESS 71
- KEY ILLUMINATION 71
- FREQUENCY LOCK FUNCTION 71
- TUNING CONTROL LOCK FUNCTION 71
- EQUALIZING RECEIVING AUDIO 72
- SETTING UP 74
- USING QUICK TRANSFER 74
- COMMUNICATION PARAMETERS 75
- RECORDING MESSAGES 76
- MESSAGE PLAYBACK 77
- CONSTANT RECORDING 77
- VOICE GUIDE 78
- CROSSBAND REPTEATER 79
- DX PACKETCLUSTER TUNE 80
- SKY COMMAND II (K-TYPE ONLY) 81
- SKY COMMAND II DIAGRAM 81
- PREPARATION 81
- CONTROL OPERATION 81
- USING TH-D7A AS A COMMANDER 82
- To COM port 84
- Straight-wired 84
- Linear Amp 85
- Use the supplied 85
- TS-480HX/ SAT 85
- MCP/ TNC 86
- DATA connector 86
- (Front view) 86
- ANT 1 connector 86
- TS-480 transceiver 87
- TM-D700 transceiver 87
- Cross-wired cable 87
- INSTALLING OPTIONS 89
- 15 INSTALLING OPTIONS 90
- TROUBLESHOOTING 91
- 16 TROUBLESHOOTING 92
- INITIAL SETTINGS 96
- PARTIAL RESET 96
- FULL RESET 96
- OPTIONAL ACCESSORIES 98
- SPECIFICATIONS 99
- 20 SPECIFICATIONS 100
- 19 INDEX 102
Related products and manuals for Boating Accessories Kenwood TS-480SAT
(66 pages)
(8 pages)
(8 pages)
Boating Accessories Kenwood TS-480HX User Manual
(104 pages)
(104 pages)
© 2020, manymanuals.com. All rights reserved. | 1.593 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals