Kenwood TS-480SAT User Manual Page 29
- Page / 104
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
4 OPERATING BASICS
21
MICROPHONE GAIN
The microphone gain must be adjusted when SSB
or AM mode is selected without using the speech
processor {pages 27, 28}.
1 Press [MIC/ 5/ RF.G].
• The current microphone gain level appears.
The range is from 0 to 100 with a default of 50.
NAR
1 REC 2 REC
5 RF.G
0 OFF
8
3 REC
9
4
7
TX MONI
6
DELAY
HF/50MHz ALL MODE TRANSCEIVER TS-480
CLR
STEP SG.SEL
CW.T
F.LOCK
M/V
SPLIT
MVFO
M.IN
TF-SET
MULTI
IF
SHIFT
AF SQL
PF
AT
CH1 CH2 CH3
PWR
MIC KEY
VOX
PROC
AGC
ENT
A / B
A=B
MODE
MHz
QMI
QMR
MENU
MTR
NB/T
ANT 1/2
FINE SCAN
DNL
BC
NR FIL
RIT
XIT
CL
ATT/PRE
2 Press and hold Mic [PTT].
• The LED on the panel lights red.
3 SSB: While speaking into the microphone, adjust
the MULTI control so that the ALC meter reflects
your voice level but does not exceed the ALC limit.
AM: While speaking into the microphone, adjust
the MULTI control so that the power meter slightly
reflects your voice level.
FM: Access Menu No. 44 and select “1” (Normal),
“2” (Medium), or “3” (High) for the microphone
gain if necessary {page 27}.
NAR
1 REC 2 REC
5 RF.G
0 OFF
8
3 REC
9
4
7
TX MONI
6
DELAY
HF/50MHz ALL MODE TRANSCEIVER TS-480
CLR
STEP SG.SEL
CW.T
F.LOCK
M/V
SPLIT
MVFO
M.IN
TF-SET
MULTI
IF
SHIFT
AF SQL
PF
AT
CH1 CH2 CH3
PWR
MIC KEY
VOX
PROC
AGC
ENT
A / B
A=B
MODE
MHz
QMI
QMR
MENU
MTR
NB/T
ANT 1/2
FINE SCAN
DNL
BC
NR FIL
RIT
XIT
CL
ATT/PRE
4 Release Mic [PTT] to return to receive.
• The LED lights green or turns off, depending
on the SQL control setting.
Note:
When using the MC-90 microphone with the MJ-88 in FM
mode, select “3” (High) for the microphone gain. The microphone
sensitivity is low in FM mode. This may cause insufficient
modulation. For other microphones, select either “1” (Normal) or “2”
(Medium).
- TS-480HX 1
- TS-480SAT 1
- FCC WARNING 2
- BY THE FCC 2
- THANK YOU 3
- PRECAUTIONS 5
- CONTENTS 6
- INSTALLATION 9
- 1 INSTALLATION 10
- ANTENNA CONNECTION 10
- GROUND CONNECTION 10
- IGNITION NOISE 10
- DC POWER CABLE CONNECTION 10
- )renutannetnalanretxenaroF( 13
- TX/ RX UNIT 15
- REMOTE CONTROL PANEL 15
- YOUR FIRST QSO 16
- 2 YOUR FIRST QSO 17
- TRANSMISSION 17
- GETTING ACQUAINTED 18
- 3 GETTING ACQUAINTED 19
- LCD DISPLAY 21
- REMOTE CONTROL PANEL (REAR) 25
- MICROPHONE 25
- OPERATING BASICS 26
- 4 OPERATING BASICS 27
- SELECTING A BAND 27
- SELECTING A MODE 27
- ADJUSTING SQUELCH 27
- SELECTING A FREQUENCY 27
- SELECTING TRANSMISSION POWER 28
- MICROPHONE GAIN 29
- MENU SETUP 30
- 5 MENU SETUP 31
- MENU CONFIGURATION 31
- )1ECIOV( 33
- )INOMXR( 33
- ALPHABETICAL FUNCTION LIST 34
- BASIC COMMUNICATIONS 35
- 6 BASIC COMMUNICATIONS 36
- AUTO ZERO-BEAT 37
- ENHANCED COMMUNICATIONS 38
- 7 ENHANCED COMMUNICATIONS 39
- TRANSMITTING A TONE 40
- TONE FREQ. ID SCAN 40
- CTCSS FREQ. ID SCAN 41
- COMMUNICATING AIDS 42
- 8 COMMUNICATING AIDS 43
- AGC (AUTOMATIC GAIN CONTROL) 43
- VOX (VOICE-OPERATED TRANSMIT) 44
- SPEECH PROCESSOR 45
- TX Filter Bandwidth (SSB/ AM) 46
- TX Equalizer (SSB/ FM/ AM) 46
- Frequency Response Curves 46
- CHANGING KEYING SPEED 47
- AUTO WEIGHTING 47
- BUG KEY FUNCTION 48
- CW MESSAGE MEMORY 48
- FREQUENCY CORRECTION FOR CW 49
- AUTO CW TX IN SSB MODE 49
- MIC UP/ DWN KEY PADDLE MODE 49
- SPECIALIZED COMMUNICATIONS 50
- 9 SPECIALIZED COMMUNICATIONS 51
- SLOW SCAN TV/ FACSIMILE 52
- REJECTING INTERFERENCE 53
- 10 REJECTING INTERFERENCE 54
- BEAT CANCEL (SSB/ FM/ AM) 55
- NOISE REDUCTION (ALL MODES) 55
- PRE-AMPLIFIER 57
- ATTENUATOR 57
- CW REVERSE (RECEPTION) 57
- MEMORY FEATURES 58
- 11 MEMORY FEATURES 59
- MEMORY RECALL AND SCROLL 59
- MEMORY TRANSFER 60
- STORING FREQUENCY RANGES 61
- MEMORY CHANNEL LOCKOUT 62
- ERASING MEMORY CHANNELS 62
- MEMORY CHANNEL NAME 62
- STORING INTO QUICK MEMORY 63
- TEMPORARY FREQUENCY CHANGES 63
- QUICK MEMORY ➡ VFO TRANSFER 63
- VFO SCAN 64
- PROGRAM SCAN 64
- 12 SCAN 65
- PROGRAM SCAN PARTIALLY SLOWED 65
- SCAN HOLD 65
- SCAN RESUME METHOD 66
- ALL-CHANNEL SCAN 66
- GROUP SCAN 67
- OPERATOR CONVENIENCES 68
- 13 OPERATOR CONVENIENCES 69
- BEEP FUNCTION 70
- BRIGHTNESS 71
- KEY ILLUMINATION 71
- FREQUENCY LOCK FUNCTION 71
- TUNING CONTROL LOCK FUNCTION 71
- EQUALIZING RECEIVING AUDIO 72
- SETTING UP 74
- USING QUICK TRANSFER 74
- COMMUNICATION PARAMETERS 75
- RECORDING MESSAGES 76
- MESSAGE PLAYBACK 77
- CONSTANT RECORDING 77
- VOICE GUIDE 78
- CROSSBAND REPTEATER 79
- DX PACKETCLUSTER TUNE 80
- SKY COMMAND II (K-TYPE ONLY) 81
- SKY COMMAND II DIAGRAM 81
- PREPARATION 81
- CONTROL OPERATION 81
- USING TH-D7A AS A COMMANDER 82
- To COM port 84
- Straight-wired 84
- Linear Amp 85
- Use the supplied 85
- TS-480HX/ SAT 85
- MCP/ TNC 86
- DATA connector 86
- (Front view) 86
- ANT 1 connector 86
- TS-480 transceiver 87
- TM-D700 transceiver 87
- Cross-wired cable 87
- INSTALLING OPTIONS 89
- 15 INSTALLING OPTIONS 90
- TROUBLESHOOTING 91
- 16 TROUBLESHOOTING 92
- INITIAL SETTINGS 96
- PARTIAL RESET 96
- FULL RESET 96
- OPTIONAL ACCESSORIES 98
- SPECIFICATIONS 99
- 20 SPECIFICATIONS 100
- 19 INDEX 102
Related products and manuals for Boating Accessories Kenwood TS-480SAT
(66 pages)
(8 pages)
(8 pages)
Boating Accessories Kenwood TS-480HX User Manual
(104 pages)
(104 pages)
© 2020, manymanuals.com. All rights reserved. | 1.334 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals