Kenwood HM-DV7 User Manual Page 68

  • Download
  • Add to my manuals
  • Print
  • Page
    / 72
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 67
68
In case of difficulty
Knowledge sections
In case of difficulty
What seems to be a malfunction is not always so. Before calling for service, check the following table
according to the symptom of your trouble.
Operation to reset
The microcomputer may fall into malfunction (impossibility
to operate, erroneous display, etc.) when the power cord is
unplugged while unit is ON or due to an external factor. In
this case, execute the following procedure to reset the mi-
crocomputer and return it to normal condition.
Unplug the power cord from the power outlet
then, while holding the STOP 7 /TUNING MODE
key depressed, plug the power cord again.
÷ Please note that resetting the microcomputer clears
the contents stored in and it returns to condition
when it left the factory.
Sound is not produced.
The STANDBY/TIMER indicator blinks in red and
no sound is put out.
The STANDBY/TIMER indicator blinks in amber.
No sound from the headphones.
Sound is not produced from the left or right
speakers.
The clock display blinks without changing the fig-
ures.
Timer operation is not possible.
÷ The input selection of the TV and/or AV amplifier is incorrect or
these devices are not turned on.
÷ Connect properly referring to "System connection".
60
÷ Adjust to an required volume.
÷ Switch MUTE OFF. £
÷ Unplug the headphone plug.
÷ When a DTS-compatible disc is played on this unit, the speakers
do not output sound. In this case, set the audio by referring to the
instruction manual of the software.
÷ A speaker cord is short-circuited. Turn power off and re-connect
the speaker cord.
÷ Adjust the present time again. &
÷ Insert correctly. 0
÷ Adjust to an required volume.
÷ Connect properly referring to "System connection". 6
÷ Adjust the present time again. &
÷ Adjust the present time referring to "Clock adjustment". &
÷ Set the timer ON time and OFF time.
÷ Press the TIMER key to set up the execution. O„
÷ Connect antennas. 6
÷ Select a band.
÷ Tune to the frequency of the desired station.
÷ Install the outdoor antenna in an apart position from the road.
÷ Switch the suspected electric appliance OFF.
÷ Install the TV or the system at an increased distance between
them.
÷ Preset stations with tunable frequencies.
÷ Preset stations again. ¤‹
Radio stations cannot be received.
Noise interferes.
A station has been preset but it cannot be re-
ceived by pressing the P.CALL key.
RemedySymptom
RemedySymptom
Amplifier section/Speakers
Tuner section
Page view 67
1 2 ... 63 64 65 66 67 68 69 70 71 72

Comments to this Manuals

No comments