Kenwood HM-DV7 User Manual download pdf (Page 11)

System connection

Preparation section

Connection of external source component

Digital signal connection

The recommended setup for "Digital Audio" is variable depending on the equipment connected to the digital

audio output. q

audio input

audio output

Cassette deck etc.

Analog signal connection

AUDIO

AUX

CD - R

OUT

S-VIDEO VIDEO

VIDEO OUT

OPTICAL

DIGITAL OUT

CD - R

PCM/BIT

STREAM

The AUDIO CD-R IN/CD-R OUT (AUDIO AUX IN) input jacks on the rear panel can be used to connect a cas-

sette deck, etc.

1. This unit always down-mixes multi-channel surround audio into 2-channel audio and outputs it from the

AUDIO CD-R OUT, DIGITAL OUT OPTICAL and PHONES jacks. However, with certain discs, this unit

outputs only the Front (L/R) channel signals in place of the down-mixed 2-channel signals.

2. In case an associated system component is connected, also read the instruction manual of the component.

3. Insert the optical-fiber cable straight into the connector until it clicks.

4. Never bend or bundle the optical-fiber cable.

Optical digital audio input

AV Amplifier

DTS disclaimer clause

When playing DTS-encoded (CDs, LDs, DVDs), excessive noise will be exhibited from the analog stereo

outputs. To avoid possible damage to the audio system, the consumer should take proper precautions

when the analog stereo outputs of the DVD player is connected to an amplification system. To enjoy

DTS Digital Surround™ playback, an external 5.1 channel DTS Digital Surround™ decoder system must

be connected to the digital output (S/P DIF, AES/EBU, or TosLink) of the DVD player.

Optical fiber cable

Digital outputs are available only from DVD, VCD and CD.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 71 72

No comments

Kenwood HM-DV7 User Manual Page 11