Kenwood P25 User Manual download pdf (Page 8)

INSTALLING THE TRANSCEIVER

For passenger safety, install the transceiver securely using an optional mounting bracket and screw

set so the transceiver will not break loose in the event of a collision.

1 Mark the position of the holes in the dash by using the mounting bracket as a

template. Drill the holes, then attach the mounting bracket using self-tapping

screws.

• Be sure to mount the transceiver in a location where the controls are within easy

reach of the user and where there is sufficient space at the rear of the transceiver

for cable connections.

2 Connect the antenna and power cable to the transceiver.

3 Slide the transceiver into the mounting bracket and secure it using

hex-headed screws.

4 Mount a microphone hanger in a location where it will be within easy reach of

the user yet not interfere with the safe operation of the vehicle.

When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same value.

Never replace a fuse with a fuse that has a higher value.

Hex-headed

screws

DC power

cable

Mounting

bracket

Antenna

connector

Power input

connector

Fuse holder

Black (–) cable

Red (+) cable

12 V vehicle

battery

Microphone

hanger

Short

plug

Fuse

Hex-headed

screw

Ground lead

(commercially available)

* The TK-5710 is shown in the above diagram.

Note: The items above shown in gray are optional accessories.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 40 41

No comments

Kenwood P25 User Manual Page 8