Kenwood KRF-V5200D User Manual download pdf (Page 31)

English

Recording mode setting in digital

audio source recording (main

unit only)

When recording a multi-channel digital audio source, it is

recommended to set up the recording mode properly to convert

the digital input into the 2-channel analog output. Usually use

the "A-REC" (Auto record) mode.

However, some discs often produce sound skipping. The "M-REC"

(Manual record) mode should be used with such a disc.

INPUT SELECTORAUTO/MONO

œ Use [INPUT SELECTOR] to select the source (CD/

DVD, DVD/6CH or VIDEO2) you want to record.

∑ Set the MD or TAPE recorder to record.

é Press and hold [AUTO/MONO] for more than 2

seconds to select a recording mode during digital

input.

Recording mode Display Operation

Recording mode off --- The digital input record mode is switched off.

Auto record mode "A-REC"

The digital input signals (DTS, Dolby Digital

or PCM) are identified automatically and

converted into stereo signals that are ready

for recording.

Manual record mode "M-REC"

The input signal type at the moment this

mode is selected is held throughout this

mode.

• When the "M-REC" mode is selected, the digital input signal is

converted to stereo signals (down-mix). But once the digital

signal is changed to other signal, no signal is output.

• When the "A-REC" mode is selected, the digital input signal is

converted to stereo signals even if the digital signal is changed.

• When the digital mode changes during recording in the "A-REC"

mode, the audio input source may be interrupted momentarily.

For "A-REC" mode:

For "M-REC" mode:

Recording

® Start playback, then start recording.

• If the audio reproduction stops in the middle due to change in

the input signals, etc., press [AUTO/MONO].

Recording audio (analog sources)

INPUT SELECTOR

œ Use [INPUT SELECTOR] to select the source (other

than "MD/TAPE") you want to record.

∑ Set the MD or TAPE recorder to record.

é Start playback, then start recording.

Recording video

INPUT SELECTOR

œ Use [INPUT SELECTOR] to select the video source

(other than "VIDEO1") you want to record.

∑ Set the video deck connected to VIDEO 1 to record.

• Select the REC MODE to record a digital input source. See

<Recording mode setting in digital audio source recording>.

é Start playback, then start recording.

• Recording may not be normal for some video software. This is

due to the copy guard condition.

B60-5676-00_00.indd 31B60-5676-00_00.indd 31 07.4.12 9:57:39 AM07.4.12 9:57:39 AM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 39 40

Comments to this Manuals

No comments

Kenwood KRF-V5200D User Manual Page 31

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Kenwood KRF-V5200D