Kenwood TM-D710GA User Manual download pdf (Page 49)

INSTALLING THE VGS-1 UNIT

Follow the instructions below to install the VGS-1 unit.

1 Remove the 8 screws from the cover of

the base unit, then remove the cover itself

from the unit.

2 From the 5 black cushions supplied with

the VGS-1, select the thickest rectangular

cushion (20 x 30 x 12 mm) and attach it to

the top surface of the VGS-1 unit.

• To prevent interference to the terminal of

the VGS-1, ensure that you attach the thick

square cushion to the base plate surface.

3 From the remaining cushions, select the

thickest square cushion (21 x 21 x 2.5

mm) and attach it to the printed circuit

board.

• The remaining cushions are not used

with this transceiver.

• Ensure that the cushion is placed within the

guidelines on the PCB.

4 Insert the VGS-1 unit into the connector

on the transceiver.

• Press down on the top of the VGS-1 unit

to ensure that it is securely attached to the

connector.

5 Replace the cover on the base unit and

secure it using the 8 screws.

Cushion

Connector

VGS-1

Cushion

Guidelines

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 55

No comments

Kenwood TM-D710GA User Manual Page 49