Kenwood TM-D710GA User Manual download pdf (Page 28)

SELECTING DUAL BAND MODE/ SINGLE BAND MODE

You can switch the transceiver between dual band operation and single band

operation by pressing [BAND SEL] (1s) of your selected band.

Dual band mode:

Single band mode (band A only):

Note: You can also turn the center partition bar display off {Menu No. 928}.

SELECTING A FREQUENCY BAND

You can change the default frequency band for bands A and B.

1 Select band A or B by pressing the [BAND SEL] control or [PF2].

2 Press [F], [BAND SEL] of your selected band.

• Each time you press [F], [BAND SEL], you cycle to the next frequency band.

• The default setting of the [PF1] key also allows you to cycle to the next frequency

band (TM-D710GE).

• When masking a band, you are restricted to using only the selectable band.

• When receiving 2 signals on the same band, the image interference, sensitivity, etc.,

Performance will decrease.

• Band A: 118 >> 144 (default) >> 220 >> 300 >> 430/440 (MHz).

• Band B: 144 >> 220 >> 300 >> 430/440 (default) >> 1200 (MHz).

Note: TM-D710GE models use the 430 MHz band and TM-D710GA models use the 440 MHz

band.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 54 55

No comments

Kenwood TM-D710GA User Manual Page 28