Kenwood TM-D710GA User Manual download pdf (Page 11)

■ Operation Panel Installation

Note: Install the operation panel in a location where it

can easily receive satellite signals.

Install the operation panel so that it is standing

perpendicular.

Do not install the bracket close to an air bag.

1 Clean and dry the installation location.

2 Remove the release paper from the base

of the panel bracket, then secure it in place

using the 3 supplied self-tapping screws.

• Allow the panel to set for a while, to ensure

it remains fast. Otherwise, vibrations may

occur.

• After removing the release paper, it cannot be

reused.

3 Attach the panel holder to the panel bracket

using the 2 supplied SEMS screws.

4 Attach the operation panel to the panel

holder so that it locks in place.

■ Power Cable Connection

Be sure to use a 12 V vehicle battery that has sufﬁ cient current capacity. If

the current to the transceiver is insufﬁ cient, the display may darken during

transmission or the transmit output power may drop excessively. Never

connect the transceiver to a 24 V battery.

SEMS screw

(M4 x 10 mm)

Panel holder

Tapping screw

(4 mm x 12 mm)

Flat washer

Adhesive tape

Panel

bracket

Passenger compartment

Engine compartment

Black (‒) cable

Red (+) cable

Rubber grommet

Fuse holder

12 V vehicle

battery

DC power cable

Fuse holder

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 54 55

Comments to this Manuals

No comments

Kenwood TM-D710GA User Manual Page 11

Comments to this Manuals

Related products and manuals for Radio Kenwood TM-D710GA