Kenwood TM-271 User Manual download pdf (Page 36)

• Memory Channel numbers L0/U0 ~ L2/U2 {page 40}, Pr

{page 43}, and AL (Weather Alert) {page 36} (K market

models only) are reserved for other functions.

5 Turn the Tuning control or press Mic [UP]/[DWN] to

select the Memory Channel in which you want to

store the data.

6 Press [MR] to store the data to the channel.

STORING ODD-SPLIT REPEATER FREQUENCIES

Some repeaters use a pair of reception and transmission

frequencies with a non-standard offset. If you store 2

separate frequencies in a Memory Channel, you can

operate on those repeaters without programming the

offset frequency and direction.

1 Store the desired reception frequency and related

data by following steps 1 to 6 given for simplex or

standard repeater frequencies {page 29}.

2 Turn the Tuning control or press Mic [UP]/[DWN] to

select your desired transmission frequency.

3 Press [F].

4 Turn the Tuning control or press Mic [UP]/[DWN] to

select the pre-programmed reception Memory

Channel in which you want to store the data.

5 Press [MR] (1s).

• The transmission frequency is stored in the Memory

Channel.

Note:

◆ When you recall an odd-split Memory Channel, “+” and “–” appear

on the display. To confirm the transmission frequency, press

[REV].

◆ Transmit offset status and reverse status are not stored in

odd-split Memory Channels.

RECALLING A MEMORY CHANNEL

USING THE TUNING CONTROL

1 Press [MR] to enter Memory Recall mode.

• The Memory Channel last used is recalled.

2 Turn the Tuning control to select your desired

Memory Channel.

•You cannot recall an empty Memory Channel.

•To restore VFO mode, press [VFO].

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 79 80

No comments

Kenwood TM-271 User Manual Page 36