Kenwood TM-271 User Manual download pdf (Page 32)

REVERSE FUNCTION

The reverse function exchanges a separate reception

and transmission frequency. So, while using a repeater,

you can manually check the strength of a signal that you

receive directly from the other station. If the station’s

signal is strong, both stations should move to a simplex

frequency and free up the repeater.

To swap the transmission and reception frequencies:

Press [REV] to switch the Reverse function ON (or

OFF).

• “R” appears when the function is ON.

Note:

◆ You can turn the Reverse function ON when you are operating in

Simplex Mode. However, it does not change the Transmission/

Reception frequencies.

◆ If pressing [REV] places the reception frequency outside the

allowable range, an error tone sounds and the function does not

operate.

◆ If pressing [REV] places the transmission frequency outside the

allowable range, pressing Mic [PTT] causes an error tone to

sound and transmission is inhibited.

◆ You cannot switch Reverse ON or OFF while transmitting.

AUTOMATIC SIMPLEX CHECK (ASC)

While using a repeater, the ASC function periodically

checks the strength of the signal you are receiving from

the other station. If the station’s signal is strong enough

to allow direct contact without a repeater, the “ ”

indicator starts blinking.

Press [REV] (1s) to switch the function ON (or OFF).

•“ ” appears when the function is ON.

• While direct contact is possible, “

” blinks.

REV ON

144.725 MHz

145.325 MHz

144.725 MHz

TX: 144.725 MHz TX: 144.725 MHz

RX: 145.325 MHz RX: 145.325 MHz

TX: 144.725 MHz TX: 145.325 MHz

RX: 145.325 MHz RX: 144.725 MHz

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 79 80

No comments

Kenwood TM-271 User Manual Page 32