Kenwood TK-2102G User Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 42
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
TK-2102G
22
ADJUSTMENT
Controls
Speaker/
microphone
jacks
Antenna
Monitor key
PTT switch
LED indicator
Speaker
Microphone
Power switch/
Volume control
Channel
selector
Frequency
The set has been adjusted for the frequencies shown in
the following table. When required, re-adjust them follow-
ing the adjustment procedure to obtain the frequencies you
want in actual operation.
Frequency
CH RX (MHz) TX (MHz)
1 162.10000 162.00000
2 150.10000 150.00000
3 173.90000 173.97500
4 162.50000 162.50000
5 162.55000 162.55000
6 162.60000 162.60000
7 162.55000 162.55000
8 162.65000 162.65000
9~16 - -
Preparations for tuning the transceiver
Before attempting to tune the transceiver, connect the
unit to a suitable power supply.
Whenever the transmitter is tuned, the unit must be con-
nected to a suitable dummy load (i.e. power meter).
The speaker output connector must be terminated with
a 8
Ω
dummy load and connected to an AC voltmeter and an
audio distortion meter or a SINAD measurement meter at all
times during tuning.
Adjustment Frequency
TEST CH
K,M
RX (MHz) TX (MHz)
Low 150.10000 150.00000
Center 162.10000 162.00000
High 173.90000 173.97500
Adjustment Points
TC2
TC201
TC1
Foil side view
TP2
R225
L212
TC201: Band-pass lter waveform adjustment
L212: AF level adjustment
TC1: Transmit VCO lock voltage adjustment
TC2: Receive VCO lock voltage adjustment
TP2: Band-pass lter test point
ANT
VR500
VR501
VR1
IC403
CV
SP MIC
CH
Component side view
ANT: Antenna connector
CH: Channel selector
SP: Speaker jack
MIC: Microphone jack
CV: VCO lock voltage adjustment terminal
VR500: DQT waveform adjustment
VR501: MAX DEV adjustment
Note: To ne tune the frequency when not using a
computer, adjust VR1.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Comments to this Manuals

No comments