Kenwood TK-2102G User Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 42
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
TK-2102G
21
ADJUSTMENT
Test Equipment Required for Alignment
Test Equipment Major Specifi cations
1. Standard Signal Generator
(SSG)
Frequency Range 150 to 174MHz
Modulation Frequency modulation and external modulation
Output –127dBm/0.1µV to greater than –47dBm/1mV
2. Power Meter
Input Impedance 50
Ω
Operation Frequency 150 to 174MHz or more
Measurement Capability Vicinity of 10W
3. Deviation Meter Frequency Range 150 to 174MHz
4. Digital Volt Meter (DVM)
Measuring Range 10mV to 10V DC
Input Impedance High input impedance for minimum circuit loading
5. Oscilloscope DC through 30MHz
6. High Sensitivity
Frequency Counter
Frequency Range 10Hz to 1000MHz
Frequency Stability 0.2ppm or less
7. Ammeter 5A
8. AF Volt Meter (AF VTVM)
Frequency Range 50Hz to 10kHz
Voltage Range 1mV to 10V
9. Audio Generator (AG)
Frequency Range 50Hz to 5kHz or more
Output 0 to 1V
10. Distortion Meter
Capability 3% or less at 1kHz
Input Level 50mV to 10Vrms
11. Spectrum Analyzer Measuring Range DC to 1GHz or more
12. Tracking Generator
Center Frequency 50kHz to 600MHz
Output Voltage 100mV or more
13. 8
Ω
Dummy Load Approx. 8
Ω
, 3W
14. Regulated Power Supply
5V to 10V, approx. 3A
Useful if ammeter equipped
The following parts are required for adjustment
1. Antenna connector adapter
The antenna connector of this radio uses an SMA termi-
nal.
Use an antenna connector adapter [SMA(f) – BNC(f) or
SMA(f) – N(f)] for adjustment. (The adapter is not provided
as an option, so buy a commercially-available one.)
2.
Jig (chassis) for adjustment(part number A10-1392-03)
Use the jig as follows:
1. Insert the coaxial antenna connector into the jig.
2. Place the unit on the jig and fi x it with 12 screws
q
.
3. Solder the antenna terminal to the terminal of the unit.
Note: Supply power from an external power supply.
Relay terminal : +
Jig (chassis) :
( )
Coaxial antenna connector
JIG
Relay terminal
UNIT
:
:
:
:
:
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

Comments to this Manuals

No comments