Kenwood KRF-V8030D User Manual download pdf (Page 7)

Preparations

MONITOR

PLAY INPLAY IN

REC OUT

AUDIO

MD/TAPE1

CD/DVDPHONO

GND

REC OUT

Make connections as shown below.

When connecting the related system components, be sure

to also refer to the instruction manuals supplied with the

components you are connecting.

Do not connect the power cord to a wall outlet until all

connections are completed.

Notes

1. Be sure to insert all connection cords securely. If their connections are

imperfect, the sound may not be produced or noise may interfere.

2. Be sure to remove the power cord from the AC outlet before plugging or

unplugging any connection cords. Plugging/unplugging connection cords

without disconnecting the power cord can cause malfunctions and may

damage the unit.

3. Do not connect power cords from components whose power consump-

tion is larger than what is indicated on the AC outlet at the rear of this unit.

Connecting audio components

To AC wall outlet

MD recorder or

Cassette deck

CD player

IN OUT

Record player

SYSTEM CONTROL

jacks !

Shape of AC outlets

U.S.A. and Canada

Other countries

3 head cassette deck or

graphic equalizer *

Setting up the system

OUT

Australia

DTS Digital Surround™ is a discrete 5.1 channel digital audio format

available on CD, LD, and DVD software which consequently cannot be

decoded and played back inside most CD, LD, or DVD players. For this

reason, when DTS-encoded software is played back through the analog

outputs of the CD, LD, or DVD player, excessive noise will be exhibited.

To avoid possible damage to the audio system, proper precautions

should taken by the consumer if the analog outputs are connected

directly to an amplification system. To enjoy DTS Digital Surround™

playback, an external 5.1 channel DTS Digital Surround™ decoder

system must be connected to the digital output (S/P DIF, AES/EBU, or

TosLink) of the CD, LD or DVD player.

This unit is equipped with DTS Digital Surround™ decoder.

DTS disclaimer clause

When you connect the unit and the CD or MD player with the

digital connection, you can enjoy the higher sound quality.

Analog connections

Audio connections are made using RCA pin cords. These cables transfer

stereo audio signal in an “analog” form. This means the audio signal

corresponds to the actual audio of two channels. These cables usually have

2 plugs each end, one red for the right channel and one white for the left

channel. These cables are usually packaged with the source unit, or are

available at your local electronics retailer.

Microcomputer malfunction

If operation is not possible or an erroneous display appears, even though

all connections have been made properly, reset the microcomputer

referring to “In case of difficulty”. §

Be sure to adhere followings. Or proper ventilation will be blocked

causing damage or fire hazard.

• Install the KRF-V8030D on the top of the system.

• Do not place any objects impairing heat radiation onto the top of unit.

• Leave a space around the unit (from the largest outside dimension

including projection) equal or greater than, shown below.

Top panel : 50 cm Side panel : 10 cm Back panel : 10 cm

CAUTION (Except for U.S.A. and Canada)

Be sure to adhere followings. Or proper ventilation will be blocked

causing damage or fire hazard.

• Install the VR-409 on the top of the system.

• Do not place any objects impairing heat radiation onto the top of unit.

CAUTION (For U.S.A. and Canada)

1 2 3 4 5 6 7 8 9 10 11 12 ... 41 42

Comments to this Manuals

No comments

Kenwood KRF-V8030D User Manual Page 7

Comments to this Manuals

Related products and manuals for Remote control Kenwood KRF-V8030D