Kenwood KRF-V8010D User Manual download pdf (Page 16)

Operations

KRF-V8010D (En/T)

Normal playback

Listening to a source component

Start playback from the selected source.

* Once setup codes are registered in the remote control, the input

name display changes according to the name of the registered

component.

Example: if you register a VCR at the VIDEO 1 jacks, "VCR" appears

instead of "VIDEO 1". RC2

• When using the remote control after initial setup, any inputs that

have not been registered with a setup code are deleted from the

cyclic list. RC4

• The INPUT SELECTOR on the front panel of the receiver always

cycles through all inputs.

1 TUNER

2 "CD" ("CD"*)

3 "TAPE" or "MD" ("TAPE"*)

4 "PHONO"("PHONO"*)

5 "VIDEO1" ("VCR1"*)

6 "VIDEO2" ("VCR2"*)

7 "VIDEO3" ("VCR3"*)

Adjusting the sound

Adjusting the tone

If a source that is not Dolby Digital is selected, you can adjust the sound

quality when the receiver is in the stereo mode.

1 Press the SOUND key to select the tone mode to be adjusted.

• The bass and treble levels are adjustable from -10 to +10 in 2 step

increments.

• The adjustment item is displayed for approximately eight sec-

onds.

• If you used the remote control to perform the above setting, press

the VIDEO key at this point to turn off the remote control’s own

adjustment mode. In this case, the input source is not switched.

The input sources change as shown below:

Selecting a source using the INPUT SELECTOR knob

Use the input selector (INPUT SELECTOR (AUDIO, VIDEO))

to select the source you want to listen to.

Selecting a source using the AUDIO key on the remote control

Selecting a source using the VIDEO key on the remote control

1 "CD" ("CD"*)

2 "TAPE" or "MD" ("TAPE"*)

3 TUNER

4 "PHONO"("PHONO"*)

1 "VIDEO1" ("VCR1"*)

2 "VIDEO2" ("VCR2"*)

3 "VIDEO3" ("VCR3"*)

4 "<--->" (Not used by this receiver.)

Use the VOLUME CONTROL (VOLUME) to adjust the

volume.

2 Use the MULTI CONTROL (TUNING/SKIP) to adjust the sound

quality.

BASS: Select this to adjust the low frequency range.

(Press the SOUND key once.)

TREB: Select this to adjust the high frequency range.

(Press the SOUND key twice.)

Once-touch low frequency emphasis (bass boost)

If a source that is not Dolby Digital is selected, you can adjust the sound

quality when the receiver is in the stereo mode.

Press the BASS BOOST key.

• Press the key once to select the maximum (+10) low frequency

emphasis setting.

• This key does not function when the receiver is in the sound quality

or ambience effects adjustment mode.

Switching back to the previous setting

Press the BASS BOOST key again.

VOLUME

VIDEO AUDIO

INPUT SELECTOR

VOLUME CONTROL

VOLUME

SOUND

TUNING/SKIP

VIDEO

MUTE

SOUND

MULTI CONTROL

VOLUME CONTROL

SOURCE DIRECT

BASS BOOST

PHONES

SPEAKERS A/B

REB +4



STEREO

TUNED

MEMO.

AUTO

ST.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

Kenwood KRF-V8010D User Manual Page 16

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Kenwood KRF-V8010D