Kenwood KRF-V5060D User Manual download pdf (Page 2)

VIDEO 2

COAXIAL

DVD

DIGITAL IN

CD / DVD

OPTICAL

VOLTAGE

SELECTOR

AC110V-120V / 220V-240V~

50 / 60Hz

SWITCHED

TOTAL 90W MAX.

AC OUTLETS

AC 220-

240V~

AC 110-

120V~

SPEAKERS

SURROUND

SPEAKERS

(8-16Ω)

CENTER

SPEAKER

(8-16Ω)

FRONT

SPEAKERS

(8-16Ω)

GRAY

WHITE GREEN BLUERED

CENTER

SUB WOOFER

PRE OUT

SUB

WOOFER

SURROUND

FRONT

DVD / 6CH INPUT

PLAY IN

VIDEO 2

DVD

AUDIO

REC OUT PLAY IN

VIDEO1

PHONO

REC OUT PLAY IN

MD / TAPE

CD / DVD

GND

VIDEO 1

OUT

VIDEO 1

VIDEO

VIDEO 2

DVD

MONITOR

OUT

ANTENNA

GND

75Ω

75µs

AM 10kHz

FM 100kHz

50µs

AM 9kHz

FM 50kHz

DE-

EMPHASIS

CHANNEL

SPACE

SYSTEM

CONTROL

As an ENERGY STAR

Partner, Kenwood

Corporation has determined that this

product meets the

ENERGY STAR

guidelines for energy efficiency.This

product can save energy. Saving energy

reduces air pollution and lowers utility bills.

Units are designed for operation as follows.

U.S.A. and Canada ........................................... AC 120 V only

Australia ........................................................... AC 240 V only

Europe and U.K. ............................................... AC 230 V only

China and Russia ............................................. AC 220 V only

Other countries .......... AC 110-120 / 220-240 V switchable*

Before applying the power

Caution : Read this page carefully to ensure safe

operation.

Safety precautions

WARNING :

TO PREVENT FIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS APPLIANCE TO

RAIN OR MOISTURE.

* AC voltage selection

The AC voltage selector switch on the rear panel is set to the voltage

that prevails in the area to which the unit is shipped. Before

connecting the power cord to your AC outlet, make sure that the

setting position of this switch matches your line voltage. If not, it

must be set to your voltage in accordance with the following direction.

AC voltage selector switch

Note :

Our warranty does not cover damage caused by excessive line

voltage due to improper setting of the AC voltage selector switch.

Move switch lever to match

your line voltage with a small

screwdriver or other pointed

tool.

For the U.S.A.

Note to CATV system installer:

This reminder is provided to call the CATV system installer's attention

to Article 820-40 of the NEC that provides guidelines for proper

grounding and, in particular, specifies that the cable ground shall be

connected to the grounding system of the building, as close to the

point of cable entry as practical.

For the United Kingdom

Factory fitted moulded mains plug

1. The mains plug contains a fuse. For replacement, use only a 13-

Amp ASTA-approved (BS1362) fuse.

2. The fuse cover must be refitted when replacing the fuse in the

moulded plug.

3. Do not cut off the mains plug from this equipment. If the plug fitted

is not suitable for the power points in your home or the cable is too

short to reach a power point, then obtain an appropriate safety

approved extension lead or adaptor, or consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and

dispose of the plug immediately, to avoid a possible shock hazard

by inadvertent connection to the mains supply.

IMPORTANT : The wires in the mains lead are coloured in accor-

dance with the following code:

Blue : Neutral

Brown : Live

Do not connect those leads to the earth terminal of a three-pin plug.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT

REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS IN-

SIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL,

WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO

ALERT THE USER TO THE PRESENCE OF UNINSULATED

“DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S EN-

CLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO

CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRI-

ANGLE IS INTENDED TO ALERT THE USER TO THE PRES-

ENCE OF IMPORTANT OPERATING AND MAINTENANCE

(SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOM-

PANYING THE APPLIANCE.

FCC WARNING

This equipment may generate or use radio frequency energy. Changes

or modifications to this equipment may cause harmful interference

unless the modifications are expressly approved in the instruction

manual. The user could lose the authority to operate this equipment

if an unauthorized change or modification is made.

NOTE:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment may

cause harmful interference to radio communications, if it is not

installed and used in accordance with the instructions. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

– – Reorient or relocate the receiving antenna.

– – Increase the separation between the equipment and receiver.

– – Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

– – Consult the dealer or an experienced radio / TV technician for

help.

For the U.S.A.

*5197/01-07/EN 26/03/2002, 2:48 PM2

1 2 3 4 5 6 7 ... 35 36

Comments to this Manuals

No comments

Kenwood KRF-V5060D User Manual Page 2

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Kenwood KRF-V5060D