Kenwood KDC-4547UB User Manual download pdf (Page 21)

English

Installation/Removing the Unit

Installation

Bend the tabs of the mounting

sleeve with a screwdriver or similar

utensil and attach it in place.

⁄

• Make sure that the unit is installed securely in place. If the

unit is unstable, it may malfunction (for example, the sound

may skip).

Removing the Hard Rubber Frame

Engage the catch pins on the removal tool and

remove the two locks on the upper level.

Upper the frame and pull it forward as shown in

the figure.

Catch

Lock

Accessory2

Removal tool

2 When the upper level is removed, remove the

lower two locations.

⁄

• The frame can be removed from the bottom side in the

same manner.

Removing the Unit

1 Refer to the section <Removing the hard rubber

frame> and then remove the hard rubber frame.

2 Detach the faceplate.

3 Insert the two removal tools deeply into the slots

on each side, as shown.

4 Lower the removal tool toward the bottom, and

pull out the unit halfway while pressing towards

the inside.

Accessory2

• Be careful to avoid injury from the catch pins on the

removal tool.

5 Pull the unit all the way out with your hands, being

careful not to drop it.

¤ CAUTION

Install this unit in the console of your vehicle.

Do not touch the metal part of this unit during and

shortly after the use of the unit. Metal part such as

the heat sink and enclosure become hot.

1 2 ... 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Kenwood KDC-4547UB User Manual Page 21

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Kenwood KDC-4547UB