Kenwood TK-3401DE User Manual download pdf (Page 12)

INSTALLING THE BELT CLIP

Do not use glue which is designed to prevent screw loosening when

installing the belt clip, as it may cause damage to the transceiver. Acrylic

ester, which is contained in these glues, may crack the transceiver’s back

panel.

Belt clip

If necessary, attach the belt clip using

the two supplied M3 x 8 mm screws.

Note:

◆ If the belt clip is not installed, its

mounting location may get hot during

continuous transmission or when left

sitting in a hot environment.

◆ The battery pack life is over when its operating time decreases even

though it is fully and correctly charged. Replace the battery pack.

◆ While operating the transceiver using a Li-ion battery pack in areas of

an ambient temperature of –10°C and lower, operating time may be

shortened.

BATTERY LIFE

The operating times listed in the table below are measured

under the following cyclic conditions:

Calculated using 5% transmit time, 5% receive time, and 90%

standby time.

Battery Type

Operating Time/ Hours (Approx.)

Digital Mode Analog Mode

Battery Saver

Off

Battery Saver

Off

KNB-45L

Supplied battery

16 H 14H 18H 14H

KNB-69L

Optional battery

22 H 18H 24H 18H

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

No comments

Kenwood TK-3401DE User Manual Page 12