Kenwood TK-3301E User Manual download pdf (Page 12)

INSTALLING THE BELT CLIP

If necessary, attach the belt clip using

the two supplied M3 x 8 mm screws.

Note: If the belt clip is not installed, its

mounting location may get hot during

continuous transmission or when left

sitting in a hot environment.

Belt clip

Do not use glue which is designed to prevent screw loosening when

installing the belt clip, as it may cause damage to the transceiver.

Acrylic ester, which is contained in these glues, may crack the

transceiver’s back panel.

If you are not using a speaker/

microphone, install the cover over

the speaker/ microphone jacks using

the supplied M3 x 6 mm screw.

Note: To keep the transceiver water

resistant, you must cover the speaker/

microphone jacks with the supplied

cover.

INSTALLING THE COVER OVER THE SPEAKER/ MICROPHONE

JACKS

Speaker/ microphone

jack cover

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

No comments

Kenwood TK-3301E User Manual Page 12