Kenwood FPM800 Troubleshooting Guide Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 27
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
b
efore using your Kenwood appliance
Read these instructions carefully and retain for future reference.
Remove all packaging and any labels.
safety
T
he blades and discs are very sharp, handle with care. Always
hold by the finger grip at the top, away from the
c
utting edge, both when handling and cleaning.
D
o not lift or carry the processor by the handle - or the handle
may break resulting in injury.
Always remove the knife blade before pouring contents from the
b
owl.
Keep hands and utensils out of the processor bowl and blender
goblet whilst connected to the power supply.
S
witch off and unplug:-
before fitting or removing parts;
when not in use;
before cleaning.
Never use your fingers to push food down the feed tube. Always
use the pusher/s supplied.
Never fit the blade unit to the power unit without the
blender goblet or compact chopper/grinder fitted.
Before removing the lid from the bowl or blender or compact
chopper/grinder from the power unit:-
switch off;
wait until the attachment/blades have completely stopped;
be careful not to unscrew the blender goblet or compact
chopper/grinder from the blade assembly.
SCALD RISK: Hot ingredients should be allowed to cool to
room temperature before blending.
Do not use the lid to operate the processor, always use the
on/off speed control.
This appliance will be damaged and may cause injury
if the interlock mechanism is subjected to excessive
force.
Always unplug your food processor when not in use.
Never use an unauthorised attachment.
Never leave the appliance unattended when it is operating.
Never use a damaged appliance. Get it checked or repaired: see
‘service & customer care’.
Never let the power unit, cord or plug get wet.
Don’t let excess cord hang over the edge of a table or worktop
or touch hot surfaces.
Do not exceed the maximum capacities stated in the
recommended speed chart.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
Only use the appliance for its intended domestic use. Kenwood
will not accept any liability if the appliance is subject to improper
use, or failure to comply with these instructions.
Misuse of your processor/blender can result in injury.
The maximum rating is based on the attachment that draws the
greatest load. Other attachments may draw less power.
Refer to the relevant section under “using the attachments” for
additional safety warnings for each individual attachment.
b
efore plugging in
Make sure your electricity supply is the same as the one shown
on the underside of your appliance.
Important – UK only
T
he wires in the cord are coloured as follows:
Green and Yellow = Earth, Blue = Neutral, Brown = Live.
The appliance must be protected by a 13A approved (BS1362)
f
use.
WARNING: THIS APPLIANCE MUST BE EARTHED.
Note:
F
or non-rewireable plugs the fuse cover MUST be refitted when
replacing the fuse. If the fuse cover is lost then the plug must not
be used until a replacement can be obtained. The correct fuse
c
over is identified by colour and a replacement may be obtained
from your Kenwood Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED
I
MMEDIATELY. An electric shock hazard may arise if an
unwanted non-rewireable plug is inadvertently inserted into a
13A socket outlet.
This appliance conforms to EC directive 2004/108/EC on
Electromagnetic Compatibility and EC regulation no. 1935/2004
of 27/10/2004 on materials intended for contact with food.
before using for the first time
1 Remove the plastic blade covers from the knife blade. Take
care the blades are very sharp. These covers should be
discarded as they are to protect the blade during manufacture
and transit only.
2 Wash the parts see ‘care & cleaning’
key
processor
1
power unit
2
Trïtan™ bowl with drive shaft
3
detachable drive shaft
4
Trïtan™ lid
5
feed tube
6
pushers
7
safety interlocks
8
cord storage (at back)
9
auto button
bk
speed/pulse control
bl
power on light
3
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 26 27

Comments to this Manuals

No comments