Kenwood KDC-BT652U User Manual download pdf (Page 26)

100

26 English

Installation/connection

Part list:

A Faceplate ...................................................................(×1)

B Escutcheon ..............................................................(×1)

C Mounting sleeve ...................................................(×1)

D Wiring harness ....................................................... (×1)

E Removal tool ..........................................................(×2)

F Flat head screw (for Nissan cars).................(×4)

G Round head screw (for Toyota cars) .........(×4)

H Microphone (3 m) (KDC-X696 only) .......... (×1)

Basic procedure

1 Remove the key from the ignition switch,

then disconnect the · terminal of the

car battery.

2 Make proper input and output wire

connections.

\ <Wiring connection> (page 28)

3 Install the unit to your car.

\ <Installing the unit> (page 29)

4 Reconnect the · terminal of the car

battery.

5 Reset the unit. (page 4)

¤Warning



The unit can only be installed in a car with a

12 V DC power supply, negative ground.



If you connect the ignition wire (red) and

the battery wire (yellow) to the car chassis

(ground), you may cause a short circuit,

that in turn may start a fire. Always connect

those wires to the power source running

through the fuse box.



Disconnect the battery’s negative terminal

and make all electrical connections before

installing the unit.



Insulate unconnected wires with vinyl tape

or other similar material. To prevent a short

circuit, do not remove the caps on the ends

of the unconnected wires or the terminals.



Be sure to ground this unit to the car’s

chassis again after mounting.



If the power is not turned ON (“PROTECT”

is displayed), the speaker wire may have a

short-circuit or touched the chassis of the

vehicle and the protection function may

have been activated. Therefore, the speaker

wire should be checked.

¤Caution



If your car’s ignition key switch does not

have an ACC position, connect the ignition

wires to a power source that can be turned

on and off with the ignition key. If you

connect the ignition wires to a constant-

voltage power source, as with battery wires,

the battery may die.



Do not use your own screws. Use only the

screws provided.



Install this unit in the console of your

vehicle. Make sure the faceplate will not hit

the lid of the console (if any) when closing

and opening.



After the installing the unit, check whether

the brake lamps, blinkers, wipers, etc. on the

car are working properly.



Mount the unit so that the mounting angle

is 30° or less.



If the fuse blows, first make sure the wires

are not touching other parts to cause a

short circuit, and then replace the old fuse

with one with a new the same rating.



Connect the speaker wires correctly to the

corresponding terminals. The unit may be

damaged or fail to work if you share the ·

wires or ground them to any metal part in

the car.



When only two speakers are being

connected to the system, connect the

connectors either to both the front output

terminals or to both the rear output

terminals (do not mix front and rear).

B64-4919-00_02_K.indb 26 11/12/21 9:33

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 99 100

Comments to this Manuals

No comments

Kenwood KDC-BT652U User Manual Page 26

Comments to this Manuals

Related products and manuals for Car video systems Kenwood KDC-BT652U