Kenwood KDC-BT652U User Manual download pdf (Page 22)

22 English

Bluetooth Setup

Selecting the Bluetooth Device

1 Press to enter Bluetooth mode.

2 Turn the volume knob to select

[SETTINGS], then press to enter.

3 Turn the volume knob to select

[PAIRING], then press to enter.

4 Turn the volume knob to select [PHONE

SELECT] or [AUDIO SELECT], then press

to enter.

5 Turn the volume knob to select a

Bluetooth device name.

6 Press the volume knob to set up the

Bluetooth device.



“ (device name)”: The selected

Bluetooth device is busy.



“- (device name)”: The selected Bluetooth

device is on standby.



“(blank) (device name)“: The Bluetooth

device is deselected.



If two cell-phones or an audio player

have already been selected, deselect one

device before selecting a new Bluetooth

device.

7 Hold to finish the procedure.



To cancel the Bluetooth mode, press .

Bluetooth Device Registration Test

You can check whether your Bluetooth device

can be registered using this unit.

1 Press and hold to enter pairing mode

“PAIRING” is displayed.

2 “PLEASE PAIR YOUR PHONE” is displayed.



When “(device name)” is displayed, select

"[PAIRING]" and press the control knob.



When “DEVICE FULL” is displayed, delete a

Bluetooth device and retry.

1. Turn the volume knob to select the

Bluetooth device, then press and hold

to confirm.

2. Turn the volume knob to select “YES”,

then press to confirm.

3 Start registering this unit by operating

the Bluetooth device.

By operating the Bluetooth device, register

the hands-free unit or audio unit (pairing).

Select “KENWOOD BT CD/R-5T1” from the

list of found units.

4 Input the PIN code (“0000”) in the

Bluetooth device.

Check that registration is complete on

the Bluetooth device. PIN code is set to

“0000” as the default. You can change this

code. Refer to [PIN CODE EDIT] under

<Bluetooth Setup> (page 23).

5 “(device name)” is displayed. Press and

hold the volume knob.

“BT TEST” is displayed.

6 The connection result, “OK” or “NG”, is

displayed.



“PAIRING”: Registration to this unit



“HF CNT”: Hands-free phoning



“AUD CNT”: Audio playback



“PB DL”: Phone Book downloading

7 Press to exit pairing mode.



Data (Phone Book, etc.) of the cell-phone

checked for connection does not remain in

this unit.

Bluetooth Setup

1 Press to enter Bluetooth mode.

2 Turn the volume knob to select

[SETTINGS], then press to enter.

3 Turn the volume knob to make a

selection, then press to confirm.



See table below for selection.



Repeat step 3 until the desired item is

selected/activated.



Press to return to the previous item.

4 Hold to finish the procedure.



To cancel the Bluetooth mode, press .

B64-4919-00_02_K.indb 22 11/12/21 9:33

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 99 100

Comments to this Manuals

No comments