Kenwood eXcelon KDC-X792 User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 116
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
English
|
13
G-Analyzer Stop Watch
The control of stop watch can be started by G-
Analyzer function.
¤
Do not use G-Analyzer stop watch on the Public roads.
1 Enter G-Analyzer Stop Watch mode (In Display
Type F)
Select “DISP > “GMA > “STOP.W”.
For how to select Function Control item, refer to
<Function Control> (page 6).
“STOP WATCH” is displayed.
2 Make the counter ready
Press the Control knob.
“Ready is displayed.
3 Start Count
When G in the vertical direction is detected during
the travel, the count automatically starts.
“Running” is displayed.
4 Stop Count
Press the Control knob.
“Stop is displayed.
When you Reset the Count
(While “Stop” is displayed)
Press the Control knob for at least 1 second.
5 Exit G-Analyzer Stop Watch mode
Press the [FNC] button.
Pressing the Control knob in step 3 allows you to start
counting.
Pressing the Control knob in step 4 allows you to restart
counting.
In Standby mode
G-Analyzer Calibration Setup
G-Analyzer requires calibration for horizontal
acceleration and braking.
To ensure accurate calibration, go through the following
steps at a level place where you can move the vehicle
straight ahead.
1 Park the vehicle in a horizontal location
2 Enter G-Analyzer Calibration setup mode (In
Display Type F)
Select “DISP > “GMA > “CAL.
For how to select Function Control item, refer to
<Function Control> (page 6).
“G-CALIBRATION” is displayed.
3 Start Calibration of horizontal direction
Press the Control knob.
Once “Move Forward” appears on the display, the
vehicle must be advanced.
4 Start Calibration of straight direction
Start moving the vehicle ahead.
Calibration of straight direction automatically starts.
When the Calibration is finished, “Calibration OK” is
displayed.
If you fail to complete the calibration, “No Calibration” is
displayed. In such a case, repeat steps 1 through 4.
5 Exit G-Analyzer Calibration setup mode
Press the [FNC] button.
B64-4048-00_00.indb 13B64-4048-00_00.indb 13 08.2.5 4:22:44 PM08.2.5 4:22:44 PM
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 115 116

Comments to this Manuals

No comments