Kenwood TS-480SAT User Manual download pdf (Page 96)

16 TROUBLESHOOTING

DEMONSTRATION MODE

The transceiver can be configured to enter the

demonstration mode for display purposes. To enter

the demonstration mode:

1 Switch the transceiver OFF.

2 Press [MENU/ F.LOCK]+[ ] to switch the

transceiver ON.

• The display brightness changes, the LED turns

ON/ OFF, and alpha-numeric segments turn

ON/ OFF automatically.

• If you operate the transceiver while in the

demonstration mode, the demonstration is

temporarily paused. But, if no operation is

performed for more than 10 seconds, the

demonstration starts again.

3 To exit the demonstration mode, first turn the

transceiver OFF, then press

[MENU/ F.LOCK]+[ ] to turn the transceiver ON.

Note:

You cannot exit the demonstration mode by simply switching

the transceiver OFF. You must switch the transceiver OFF then press

[MENU/ F.LOCK]+[ ]

to turn the transceiver ON in order to exit the

demonstration mode.

MICROPROCESSOR RESET

If your transceiver seems to be malfunctioning,

resetting the microprocessor default settings may

resolve the problem. There are 2 levels of resetting

the microprocessor of the TS-480 transceiver: Partial

Reset and Full Reset.

INITIAL SETTINGS

For each VFO, the factory defaults for the operating

frequency and mode are as follows:

• VFO A: 14.000.00 MHz/ USB

• VFO B: 14.000.00 MHz/ USB

The Memory channels and Quick Memory channels

have no data stored.

PARTIAL RESET

Perform a Partial Reset if a key or control does not

function according to the instructions in this manual.

The following data is NOT erased by performing a

Partial Reset.

• Memory channel data

• Menu settings

• Antenna tuner preset data

• ANT 1/ ANT 2 selection data

• Frequency and mode data for the Auto Mode

function

•Various adjustment setting values

Reset the transceiver by pressing [A/B / M/V]+[ ].

•A confirmation message appears when performing

the Partial Reset. Press [A/B / M/V] to proceed.

Otherwise, press any other key to cancel the

Partial Reset and return to normal operation.

• The VFOs reset to the factory default values.

FULL RESET

Perform a Full Reset if you want to erase all the data

in all the memory channels. In addition, this function

resets all the settings that you customized, to the

factory defaults (i.e.- menu settings, antenna tuner

preset data, etc.).

Reset the transceiver by pressing

[A=B/ SPLIT]+[ ].

A confirmation message appears when performing

Full Reset. Press [A=B/ SPLIT] to proceed.

Otherwise, press any other key to cancel the Full

Reset and return to normal operation.

When you perform the Full Reset:

• All frequencies, modes, memory data, adjustment

values, and AT preset data are set to the factory

default values.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 102 103 104

Comments to this Manuals

No comments

Kenwood TS-480SAT User Manual Page 96

Comments to this Manuals

Related products and manuals for Boating Accessories Kenwood TS-480SAT