Kenwood TS-480SAT User Manual Page 45
- Page / 104
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
37
8 COMMUNICATING AIDS
SPEECH PROCESSOR
The Speech Processor levels out large fluctuations in
your voice while you speak. When using SSB, FM, or
AM mode, this leveling action effectively raises the
average TX power, resulting in a more
understandable signal. The amount of voice
compression is fully adjustable. You will notice that
using the Speech Processor makes it easier to be
heard by distant stations.
1 Select USB, LSB, FM, or AM mode.
2 Press [PROC/ 9] to turn the Speech Processor
ON.
• “PROC” appears.
3 Press [PROC/ 9] (1 s) to enter the Speech
Processor input level adjustment mode.
4 As you speak into the microphone, turn the
MULTI control so that the compression meter
indicates that the compression level is around
10 dB while you speak.
• Using higher compression will not improve your
signal clarity or apparent signal strength.
Excessively compressed signals are more
difficult to understand due to distortion and are
less pleasant to hear than signals with less
compression.
5 Press [PROC/ 9] (1 s) to exit the Speech
Processor input level adjustment mode.
6 Press [MIC/ 5/ RF.G] to enter the Speech
Processor output level adjustment mode.
• As you speak into the microphone, turn the
MULTI control so that the ALC meter reflects
according to your voice level but does not
exceed the ALC limit. Press [MIC/ 5/ RF.G] to
exit when you finish the adjustment mode.
XIT (TRANSMIT INCREMENTAL TUNING)
Similar to RIT, XIT provides the ability to change your
transmission frequency by ±9.99 kHz in steps of 10 Hz
without changing your reception frequency. If the Fine
Tuning function is ON, the frequency step size
becomes 1 Hz.
1 Press [XIT].
• “XIT” and the XIT offset appear.
2 If required, press [CL] to reset the XIT offset to 0.
3 Turn the RIT/ XIT control to change your transmit
frequency.
4 To turn XIT OFF, press [XIT].
• “XIT” and offset frequency display disappear.
The transmission frequency is returned to the
frequency that was selected prior to step 1.
Note:
◆
If the Fine Tuning function is ON, you can adjust the frequency
within
±
9.99 kHz.
◆
The frequency shift set by the
XIT
control is also used by the RIT
function. Therefore, changing or clearing the XIT offset also
affects the RIT offset.
◆
When the XIT frequency exceeds the limit of available
transmission frequency, the transceiver automatically stops
transmitting.
TX power
TX power
Time
Time
Speech
Processor
OFF
Speech
Processor
ON
- TS-480HX 1
- TS-480SAT 1
- FCC WARNING 2
- BY THE FCC 2
- THANK YOU 3
- PRECAUTIONS 5
- CONTENTS 6
- INSTALLATION 9
- 1 INSTALLATION 10
- ANTENNA CONNECTION 10
- GROUND CONNECTION 10
- IGNITION NOISE 10
- DC POWER CABLE CONNECTION 10
- )renutannetnalanretxenaroF( 13
- TX/ RX UNIT 15
- REMOTE CONTROL PANEL 15
- YOUR FIRST QSO 16
- 2 YOUR FIRST QSO 17
- TRANSMISSION 17
- GETTING ACQUAINTED 18
- 3 GETTING ACQUAINTED 19
- LCD DISPLAY 21
- REMOTE CONTROL PANEL (REAR) 25
- MICROPHONE 25
- OPERATING BASICS 26
- 4 OPERATING BASICS 27
- SELECTING A BAND 27
- SELECTING A MODE 27
- ADJUSTING SQUELCH 27
- SELECTING A FREQUENCY 27
- SELECTING TRANSMISSION POWER 28
- MICROPHONE GAIN 29
- MENU SETUP 30
- 5 MENU SETUP 31
- MENU CONFIGURATION 31
- )1ECIOV( 33
- )INOMXR( 33
- ALPHABETICAL FUNCTION LIST 34
- BASIC COMMUNICATIONS 35
- 6 BASIC COMMUNICATIONS 36
- AUTO ZERO-BEAT 37
- ENHANCED COMMUNICATIONS 38
- 7 ENHANCED COMMUNICATIONS 39
- TRANSMITTING A TONE 40
- TONE FREQ. ID SCAN 40
- CTCSS FREQ. ID SCAN 41
- COMMUNICATING AIDS 42
- 8 COMMUNICATING AIDS 43
- AGC (AUTOMATIC GAIN CONTROL) 43
- VOX (VOICE-OPERATED TRANSMIT) 44
- SPEECH PROCESSOR 45
- TX Filter Bandwidth (SSB/ AM) 46
- TX Equalizer (SSB/ FM/ AM) 46
- Frequency Response Curves 46
- CHANGING KEYING SPEED 47
- AUTO WEIGHTING 47
- BUG KEY FUNCTION 48
- CW MESSAGE MEMORY 48
- FREQUENCY CORRECTION FOR CW 49
- AUTO CW TX IN SSB MODE 49
- MIC UP/ DWN KEY PADDLE MODE 49
- SPECIALIZED COMMUNICATIONS 50
- 9 SPECIALIZED COMMUNICATIONS 51
- SLOW SCAN TV/ FACSIMILE 52
- REJECTING INTERFERENCE 53
- 10 REJECTING INTERFERENCE 54
- BEAT CANCEL (SSB/ FM/ AM) 55
- NOISE REDUCTION (ALL MODES) 55
- PRE-AMPLIFIER 57
- ATTENUATOR 57
- CW REVERSE (RECEPTION) 57
- MEMORY FEATURES 58
- 11 MEMORY FEATURES 59
- MEMORY RECALL AND SCROLL 59
- MEMORY TRANSFER 60
- STORING FREQUENCY RANGES 61
- MEMORY CHANNEL LOCKOUT 62
- ERASING MEMORY CHANNELS 62
- MEMORY CHANNEL NAME 62
- STORING INTO QUICK MEMORY 63
- TEMPORARY FREQUENCY CHANGES 63
- QUICK MEMORY ➡ VFO TRANSFER 63
- VFO SCAN 64
- PROGRAM SCAN 64
- 12 SCAN 65
- PROGRAM SCAN PARTIALLY SLOWED 65
- SCAN HOLD 65
- SCAN RESUME METHOD 66
- ALL-CHANNEL SCAN 66
- GROUP SCAN 67
- OPERATOR CONVENIENCES 68
- 13 OPERATOR CONVENIENCES 69
- BEEP FUNCTION 70
- BRIGHTNESS 71
- KEY ILLUMINATION 71
- FREQUENCY LOCK FUNCTION 71
- TUNING CONTROL LOCK FUNCTION 71
- EQUALIZING RECEIVING AUDIO 72
- SETTING UP 74
- USING QUICK TRANSFER 74
- COMMUNICATION PARAMETERS 75
- RECORDING MESSAGES 76
- MESSAGE PLAYBACK 77
- CONSTANT RECORDING 77
- VOICE GUIDE 78
- CROSSBAND REPTEATER 79
- DX PACKETCLUSTER TUNE 80
- SKY COMMAND II (K-TYPE ONLY) 81
- SKY COMMAND II DIAGRAM 81
- PREPARATION 81
- CONTROL OPERATION 81
- USING TH-D7A AS A COMMANDER 82
- To COM port 84
- Straight-wired 84
- Linear Amp 85
- Use the supplied 85
- TS-480HX/ SAT 85
- MCP/ TNC 86
- DATA connector 86
- (Front view) 86
- ANT 1 connector 86
- TS-480 transceiver 87
- TM-D700 transceiver 87
- Cross-wired cable 87
- INSTALLING OPTIONS 89
- 15 INSTALLING OPTIONS 90
- TROUBLESHOOTING 91
- 16 TROUBLESHOOTING 92
- INITIAL SETTINGS 96
- PARTIAL RESET 96
- FULL RESET 96
- OPTIONAL ACCESSORIES 98
- SPECIFICATIONS 99
- 20 SPECIFICATIONS 100
- 19 INDEX 102
Related products and manuals for Boating Accessories Kenwood TS-480SAT
(104 pages)
Boating Accessories Kenwood TS-480HX User Manual
(104 pages)
(104 pages)
Boating Accessories Kenwood TM-451A User Manual
(130 pages)
(130 pages)
© 2020, manymanuals.com. All rights reserved. | 0.909 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals