Kenwood TK-5910 User Manual download pdf (Page 30)

TRUNKING CALLS

mAKing A Telephone cAll

■ Manual Dialing

1 Press the key programmed as Autodial.

• The last called unit appears on the display.

• Press the

PF 2 key to switch the display between the unit name and the list

number.

2 Press and hold the PF 2 key to enter Store & Send mode.

3 Enter the desired digits using the DTMF keypad.

• Alternatively, you can select a digit by rotating the CH control, and then set the

selected digits by pressing the GRP key. Repeat this process to enter the

entire number.

4 Press the PTT switch to make the call.

• Alternatively, you can press the PF 4 key to page the selected unit, rather than

making a call.

■ Selecting a Number from the List

1 Press the key programmed as Autodial.

• The last called unit appears on the display.

• Press the

PF 2 key to switch the display between the unit name and the list

number.

2 Rotate the CH control to select your desired list number.

3 Press the PTT switch to make the call.

• Alternatively, you can press the PF 4 key to page the selected unit, rather than

making a call.

receiving A Telephone cAll

1 When a call is received, a ringing tone will sound and “PHONE CALL” will

appear on the display.

2 Press and hold the PTT switch to speak, and release it to receive.

• Only one person can speak at a time.

mAKing A STATuS cAll

1 Select your desired zone and channel.

2 Press the key programmed as Status to enter status mode.

3 Rotate the CH control to select the status ID you want to transmit.

4 Press the PTT switch or the PF 4 key to initiate the Status call.

• After the status call has been successfully received by the called unit, “COMPLETE”

appears on the display.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

No comments

Kenwood TK-5910 User Manual Page 30