Kenwood eXcelon KAC-X10D User Manual download pdf (Page 6)

6 English

Controls

1 Fuse (40 A × 1)

NOTE

If you can’t find the specified capacity fuse at your store etc., consult your

Kenwood dealer.

2 Battery terminal

3 Ground terminal

4 Power control terminal

Controls the unit ON/OFF.

NOTE

Controls the unit power. Be sure to connect it with all the systems.

5 Speaker output terminals

As this unit accepts speakers with a minimum impedance of 1 ohm, connect

speakers with 1-ohm or higher impedance to these terminals.

2CAUTION

The rated input of the speakers should be no less than the maximum output

of the amplifier. Otherwise malfunction may result.

6 ISF (infrasonic filter) switch

Ultralow frequencies that cannot be reproduced even by a subwoofer

speaker do not become sound but become unnecessary oscillations, which

affect the sound by causing distortion, etc. Setting this switch to "15 Hz" or

"25 Hz" cuts the frequencies below the respective frequency.

This improves the reproduction performance of the speakers by eliminating

unnecessary oscillations which will not become sound.

7 LPF(Low-Pass Filter) FREQUENCY control

This control adjusts the frequency band output from this unit.

8 LINE OUT FILTER switch

Changing over the audio signal output to the LINE OUT terminal.

ON position:

The audio signal adjusted when setting LPF, INPUT SENSIVITY control and

Bass boost (optional accessory) is output to the LINE OUT terminal.

OFF position:

The audio signal input from the LINE IN terminal is output to the LINE OUT

terminal (through output).

2CAUTION

The volume of the audio output to the LINE OUT terminal is different in ON

and OFF position. Remember this when changing the LINE OUT FILTER switch

from ON to OFF.

9 INPUT SENSITIVITY control

Set this control according to the pre-output level of the center unit

connected with this unit.

NOTE

For the pre-output level, refer to the <Specifications> in the instruction

manual of the center unit.

0 REMOTE terminal

Connects the Remote cable.

NOTE

Use the Remote cable of the accessory.

! LINE IN terminal

@ LINE OUT terminal

The audio signal set with the LINE OUT FILTER switch will be output.

# Power idndicator

When the power is turned on, the Power indicator lights.

If the Power indicator does not light when the power is turned on, the

protection function may be activated. Check whether there is any indication

of trouble. (See page 2)

$ BOOST LEVEL (Bass boost level) control

Sets the level by which the low frequency range should be boosted.

% Power idndicator

^ FREQUENCY (Bass boost frequency) control

Sets the center frequency around which the low frequency range should be

boosted.

}

pq rs t uvwx yz{

Remote controller

(

Optional accessory

)

B64-3517-00_K_English.indd 6B64-3517-00_K_English.indd 6 06.10.16 10:34:15 AM06.10.16 10:34:15 AM

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments

Kenwood eXcelon KAC-X10D User Manual Page 6

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Kenwood eXcelon KAC-X10D