Kenwood KCA-BT300 User Manual download pdf (Page 32)

KCA-BT300

Accessories/ Installation Procedure

Accessories

3 m (9.5 ft) ..........1

..........1

..........2

..........1

Installation Procedure

1. To prevent a short circuit, remove the key from the

ignition and disconnect the - battery.

2. Set the Type switch.

3. Make the proper input and output wire

connections for each unit.

4. Install the unit in your car.

5. Reconnect the - battery.

6. Press the reset button on the control unit.

• Insulate unconnected wires with vinyl tape or other similar

material. To prevent a short circuit, do not remove the caps

on the ends of the unconnected wires or the terminals.

• After the unit is installed, check whether the brake lamps,

blinkers, wipers, etc. on the car are working properly.

For Good Reception

To assure good reception, note the following:

• Communicate with the cell-phone within the line-

of-sight distance of 10 m (30 ft). The communication

range becomes shorter depending on the

surrounding environment. The communication

range also becomes shorter when there is an

obstacle between this unit and the cell-phone. The

above maximum communication range (10 m) is

not always assured.

• Keep this unit away from other electric components

(AV components) as far as possible. If they are near,

call connection can fail, TV or radio noise can be

generated, or poor reception can occur.

• A broadcast station or walkie-talkie located nearby

can interfere with communication due to too strong

signal.

Setting the Type Switch

Set the Type switch according to the type of the

control unit connected. See the Type switch setting

column of the model list (page 4).

For the models released after April 2010, set the Type

switch as follows.

- For the model connected with the 5L connector

1: OFF, 2: OFF, 3: OFF

- For the model connected with the KAB connector

1: OFF, 2: ON, 3: OFF

- For more details, see the following web site. Set the

Type switch according to the web site when the

above setting is different from that of the web site.

www.kenwood.com/cs/ce/bt/

OFF

1: Display Character Conversion Function

When the control unit cannot display accent characters

("u", "a", etc.), it converts these characters to upper-case

alphabetic characters.

OFF: Do not covert characters.

ON: Convert characters.

2: Specifying the Connector to Connect

Specify the type of the connector to be connected to the

control unit.

OFF: Use the 5L connector.

ON: Use the KAB connector.

3: Specifying the Control Unit Type

Specify the type of the control unit to connect to.

OFF: Set when no control unit type is specified in Model list,

or the control unit type is not in the model list.

ON: Set when the control unit type is specified in Model list.

B64-4713-00_10_KCA-BT300_KE.indb 32B64-4713-00_10_KCA-BT300_KE.indb 32 10/03/12 14:5110/03/12 14:51

1 2 ... 27 28 29 30 31 32 33 34 35

Comments to this Manuals

No comments

Kenwood KCA-BT300 User Manual Page 32

Comments to this Manuals

Related products and manuals for Wireless Headsets Kenwood KCA-BT300