Kenwood TK-3202 User Manual download pdf (Page 5)

TK-3202/3206

DISASSEMBLY FOR REPAIR

■ Removing the case assembly from the chassis.

1. Remove the volume knob

and channel knob

2. Remove the two screws

3. Lift and remove the chassis from the case assembly

(Use a flat-blade screwdriver to easily lift the chassis.)

■ Removing the TX-RX unit from the chassis.

1. Remove the packing

from the SP / MIC jack of the TX-

RX unit.

2. Remove the eleven screws

fixing the TX-RX unit.

3. Remove the fixing bracket

of the SP / MIC.

4. Remove the solder of the antenna terminal with a soldering

iron

5. Remove the solder of the positive terminal with a soldering

iron

Note: You can remove the TX-RX unit from the chassis without

removing the solder at the positive terminal. However,

in this case, you can not attach the packing (G53-1605-

03) that is on the positive terminal to the chassis in

assembling. So, it is advisable to remove the solder on

the positive terminal first.

6. Remove the FPC from the flat cable connector

7. Lift and remove the TX-RX unit from the chassis

Ω.

■ Removing the battery release lever from the case

assembly.

1. Press the upper part of the lever toward the inside of the

case assembly. One side of the shaft will be removed

2. Lift and remove the battery release lever from the case

assembly

■ Attaching the battery release lever to the case

assembly.

1. Insert one side of the shaft into the hole at the lever fitting

section on the case assembly

Caution : The thin spring (G01-4543-04) should be positioned

above the two tabs of the lever.

2. Tilt the battery release lever slightly forward

, so that the

thick spring (G01-4542-04) is positioned below the case

surface.

3. With the thick spring positioned below the case surface,

attach the other side of the shaft to the case assembly by

pressing the battery release lever

until it snaps into place

Caution : Be careful not to tilt the battery release lever too

forward.

If the battery release lever is pushed in this state

where the two tabs come below the case surface,

there is a possibility of damaging the two tabs.

A thin spring

Shaft

Two tabs

A thick spring

1 2 3 4 5 6 7 8 9 10 ... 44 45

Comments to this Manuals

No comments

Kenwood TK-3202 User Manual Page 5

Comments to this Manuals

Related products and manuals for Two-way radios Kenwood TK-3202