Kenwood TK-190 User Manual download pdf (Page 15)

This function can be selected only when the scrambler

board has not been installed.

This function can be selected only when the ANI board has

been installed.

This function can be selected only when the scrambler

board has been installed.

Note:

◆

If your dealer programs “Shift” onto a PF key or the toggle switch,

the remaining PF keys can be programmed with an additional

function. To use the additional functions, you must first press and

hold the Shift key, then press the function key you desire. The

toggle switch and the key programmed with “Shift” cannot be

programmed with an additional function.

◆

When the same auxiliary function is programmed onto both a PF

key and the toggle switch, an error will occur on the PF key and it

cannot be used.

■ Function Descriptions

• AUX: Press to turn AUX ON. The dealer selectable

optional board will activate. Press again to turn AUX

OFF. When AUX is ON, “AUX” appears on the display.

• Channel Down: Press to decrease the channel by 1

step. Press and hold to continuously scroll through the

channels. Unprogrammed channels will be skipped.

Note: Your dealer can program the “Roll Over” (default) or

“Dead End” feature. When Roll Over is programmed, pressing

Channel Down while you are at the lowest channel will cause

the transceiver to select the highest channel, and begin the

decrease cycle again. When Dead End is programmed,

pressing Channel Down while you are at the lowest channel will

not change the channel number.

• Channel Name: Press to change the display between

the channel number and the channel name. Your

dealer can program a channel name for each channel

with up to 7 characters.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 30 31

No comments

Kenwood TK-190 User Manual Page 15