Kenwood RA-5000 User Manual download pdf (Page 14)

RV-7000/RV-6000/RA-5000

Connections

Speaker placement

RV-7000 (Surround Back speaker)

Center speaker

Front speaker

Subwoofer

Listening

position

Surround speaker

Front speaker

Surround speaker

Surround Back speaker

RV-7000 (Front Height speaker)

Center speaker

Front speaker

Subwoofer

Listening

position

Surround speaker

Front speaker

Surround speaker

Front Height speaker

RV-6000

Center speaker

Front speaker

Subwoofer

Listening

position

Surround speaker

Front speaker

Surround speaker

Surround Back speaker

Notes on connections

When connecting the related system components, be sure to

refer to the instruction manuals supplied with the components

you are connecting.

• Be sure to remove the power cord from the AC outlet

before plugging or unplugging any connection cords.

Plugging/unplugging connection cords without

disconnecting the power cord can cause malfunctions

and may damage the unit.

• Be sure to insert all connection cords securely. If their

connections are imperfect, the sound and video may not

be produced or there will be noise interference.

• If this unit is installed in the proximity of a source of

magnetism such as a magnet, color irregularities due to

interference with the speakers may be observed on the

TV monitor screen. Be careful in the installation.

Microcomputer malfunction

If operation is not possible or an erroneous display appears,

even though all connections have been made properly, reset the

microcomputer by referring to <Resetting the microcomputer>.

¤CAUTION

The power of this equipment will not be completely cut off

from the wall outlet when the power switch is turned off.

Install the equipment so that the wall outlet is easily

accessible and, in case of emergency, immediately unplug the

power cord from the wall outlet.

¤CAUTION

Be sure to adhere to the following, or proper ventilation

will be blocked causing damage or fire hazard.

• Do not install the unit on the rear, side or top panel.

• Do not cover the unit with a cloth or install the unit on a

carpet or mattress.

• Do not install the unit in a poorly ventilated place.

• Leave some space around the unit (from the largest outside

dimension including projection) equal to or greater than,

shown below.

Top panel : 50 cm

Side panel : 10 cm

Back panel : 10 cm

¤CAUTION

Do not connect the power cord to a wall outlet until all

connections are completed.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Comments to this Manuals

No comments

Kenwood RA-5000 User Manual Page 14

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Kenwood RA-5000